1.5.2.3 AT^SSTR Remote-SAT Response – Setup Call (16)
Write command
AT^SSTR=16,
<status>
The TA indicates if the call setup has been accepted by the user.
For further details please refer to chapter “AT^SSTGI
Response
After confirmation phase the TA may show a dialling animation on the screen until a mandatory response parameter is issued.
^SSTR: <pac>, <TermQualifier>, <TerminationCauseText>
For a detailed explanation of these parameters please refer to chapter “AT^SSTGI
OK
Parameters
<cmdType> 16 – Proactive command ID, see Table 1.
<status> Unsigned Integer, range
0 | Command performed successfully |
| Indicate that the user has accepted the call request. |
16 | Proactive SIM session terminated by user |
20 | USSD/SS Transact terminated by user |
32 | TA currently unable to process command |
132TA currently unable to process command because screen is busy.
34User did not accept the proactive command. Indicate that the user has denied the call request.
35User cleared down call before connection or network release
ReferenceNote
Siemens
MC35_SAT_01_v02.00 | Page 44 of 65 | 11.01.2002 |