Siemens SS2604 manual Connection Log Messages, Message Description

		Operation and Status
	•	The "Clear Log" button will restart the Log, while the Re-
		fresh button will update the messages shown on screen.
Buttons
Connect	If not connected, establish a connection to your ISP.
Disconnect	If connected to your ISP, hang up the connection.
Clear Log	Delete all data currently in the Log. This will make it easier to
	read new messages.
Refresh	Update the data on screen.

Connection Log Messages

Message	Description
Connect on Demand	Connection attempt has been triggered by the "Connect auto-
	matically, as required" setting.
Manual connection	Connection attempt started by the "Connect" button.
Reset physical connection	Preparing line for connection attempt.
Connecting to remote	Attempting to connect to the ISP's server.
server
Remote Server located	ISP's Server has responded to connection attempt.
Start PPP	Attempting to login to ISP's Server and establish a PPP con-
	nection.
PPP up successfully	Able to login to ISP's Server and establish a PPP connection.
Idle time-out reached	The connection has been idle for the time period specified in
	the "Idle Time-out" field. The connection will now be termi-
	nated.
Disconnecting	The current connection is being terminated, due to either the
	"Idle Time-out" above, or "Disconnect" button being clicked.
Error: Remote Server not	ISP's Server did not respond. This could be a Server problem,
found	or a problem with the link to the Server.
Error: PPP Connection	Unable to establish a PPP connection with the ISP's Server.
failed	This could be a login problem (name or password) or a Server
	problem.
Error: Connection to	The existing connection has been lost. This could be caused by
Server lost	a power failure, a link failure, or Server failure.
Error: Invalid or unknown	The data received from the ISP's Server could not be proc-
packet type	essed. This could be caused by data corruption (from a bad
	link), or the Server using a protocol which is not supported by
	this device.

41