Siemens 2602 manual Installing and Configuring TCP/IP, Install the TCP/IP Protocol

CHAPTER 4

INSTALLING AND CONFIGURING TCP/IP

To access the Internet through the SpeedStream 2602 DSL/Cable Router, you must configure it and your network computers with same IP subnet. Manually configure the IP address for client computers or obtain it automatically from the SpeedStream 2602’s DHCP service.

The default network settings for the SpeedStream 2602 are:

IP Address: 192.168.254.254

Subnet Mask: 255.255.255.0

Password: admin

You can change these settings to comply with your network requirements; however, you must first configure at least one computer to access the SpeedStream 2602 management interface.

Install the TCP/IP Protocol

If TCP/IP is not installed on your computer, follow these instructions:

1.Click Start/Settings; then click Control Panel.

2.Double-click Network to display the Configuration tab in the Network window.

3.Click Add to add a network component to your computer.

4.Double-click Protocol to add the TCP/IP protocol.

Figure 4-1. Select Network Component Type

5.In the manufacturers list, select Microsoft; then select TCP/IP in the Network Protocols list. Click OK to return to the Network window.

4-1