5. INSTALLATION PROCEDURE
1)Turn the printer power ON.
2)Hold the raised sides firmly and lift upwards to unhook the printer cover. (1)
3)Hold both sides of the printer cover and open it until it stops. (2)
4)Check for the correct orientation of the receipt roll, and put it into the paper holder.
Pull the receipt until it extends past the paper outlet for about 5 cm (3), and then close the printer cover by pressing it’s front center gently until a positive lock is felt.
Print Cover | 1 | Raised | |
edge | |||
|
|
2
3
Receipt Roll
CAUTION!
1.Use only TOSHIBA TEC specified paper. Use of
2.Do not subject the thermal receipt roll to water, oil, or heat source as this will darken the paper.
3.Load the receipt roll in the correct orientation. Failure to do this may cause a paper jam error.
4.Care must be taken not to damage the print head and platen when the printer cover is opened as this may cause a poor print or a printer failure.
5.Do not open the printer cover while the printer is printing.
6.Do not hold the receipt while the printer is printing. Doing so may cause a paper jam.
7.When closing the printer cover, do not press it down too hard.
8.Do not put anything on the printer cover or push the cover too strongly. Doing so may cause a print failure.