Toshiba EO1-33015 owner manual Installation Procedure, Connecting the Power Cord and Cables

Page 13

6. INSTALLATION PROCEDURE

EO1-33015

6.1 CONNECTING THE POWER CORD AND CABLES

6. INSTALLATION PROCEDURE

6.1 CONNECTING THE POWER CORD AND CABLES

WARNING!

Turn the POWER SWITCH to OFF before connecting the power cord or cables.

[B-672]

[B-682]

Expansion I/O

Cable

	4		1	2
1			1	2
1	3
	3			3
		2		3
		2	Power Cord
		1	Power Cord	4
		2	Serial Interface Cable (RS-232C)	4
		2	Serial Interface Cable (RS-232C)

3Parallel Interface Cable (Centronics)

4 Expansion I/O Cable

Fig. 6-1

NOTES: Different cables cannot be used at the same time.

6.2 HOLDER STAND INSTALLATION

Fit the left and right side holders into the dowels of the holder base and fasten the side holders to the holder base with the thumbscrews.

Thumbscrew

Left Side Holder

Right Side Holder

Holder Base

Dowel

Fig. 6-2

6-1

Image 13

Contents 670/680-QQ Series Energy Star is a U.S. registered mark Meanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents Introduction AccessoriesApplicable Model 7 2 T S 1 0 Q QPrinter SpecificationsMSI, ITF, NW-7, CODE39, CODE93, CODE128 RM4SCC Royal Mail 4STATE Cutomer CodeOption Ribbon MediaFRONT/REAR View OverviewOperation Panel Front ViewDIP SW DIP Switch Functions B-672 onlySetting UP the Printer SET UP ProcedureRequirements for Operation Interface CablesConnecting the Power Cord and Cables Installation ProcedureHolder Stand Installation Head Lever Position Loading the RibbonStep Loading the Media Do not Move the Media Guides using the screwLoading the Media An easy way to set the black mark sensor position Setting the feed gap sensor positionCutter Module Media Outlet Loading the Media Inserting the Optional Flash Memory Card B-672 only Inserting the Optional Pcmcia Card B-682 only CARE/HANDLING of the Media and Ribbon Cleaning General MaintenanceWhite Screw Stud Ribbon End Sensor Plate Pinch Roller Lever Covers and Panels Under the Media GuidesRemoving Jammed Media Cleaning the strip unit Cleaning the Cutter UnitThreshold setting procedure Threshold SettingError Message Problem Solution TroubleshootingRibbon Error Head ErrorCutter Error ErrorProblem Solution