Toshiba owner manual Safety Precaution, Model Name TDP-P75

Page 2
USA only
USA only

English

SAFETY PRECAUTION

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.

WARNING: Handling the cord on this projector, or the cords associated with accessories sold with this projector, will expose you to lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands after handling.

WARNING: The lamp used in this projector contains mercury. Disposal of mercury may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae.org.

MODEL NAME: TDP-P75

USA only

TRADE NAME: DATA PROJECTOR

MODEL NAME: TDP-P75

Tested To Comply

 

With FCC Standards

 

FOR HOME OR OFFICE USE

 

FCC NOTICE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

2 SAFETY PRECAUTION

Page 1 Page 3
Image 2
Page 1 Page 3
Contents TDP-P75 Safety Precaution Model Name TDP-P75USA only Canada only Source of light Important Safety InstructionsPower sources HeatVentilation Power cord protectionCleaning Water and moistureDo not place the product vertically AccessoriesLightning storms Do not stack componentsSafety check Damage requiring serviceReplacement parts ServicingFor long periods of time Power Supply Cord SelectionDo not use the product in a closed installation state Important Precautions Save Original Packing MaterialsExemption Clauses Other Notes and Information CopyrightsRemote Control Batteries Notational Conventions Used in This ManualContents Regulation statements Troubleshooting SpecificationsAdditional Information Shipping contents OverviewRear side Projector exterior viewFront / Upper side Bottom sideControls and functions Control panelName Main Function Remote controlRemote Control Front Rear Operating the remote control Preparing and using the remote controlLoading dry-cell batteries into the remote control Remote controlSwitching operation modes Operating a computer Operating a computer using the remote controlConnecting a computer Floor front Positioning your projectorChoosing a location II. Ceiling frontScreen As seen from above ConnectionProjection distance and size Min length =480i 480p 576i 576p 720p 50/ 60 Hz 1080i 50/ 60 Hz Connecting to a computerConnecting to a Component Video device Connecting Video and S-Video devices Video or Video devices Video cable or Audio cableOperation Start upAuto-adjusting the image Adjusting the imageAdjusting the height Fine-tuning the image size and clarityCorrecting keystone Switching input signalsAdjusting the volume For exampleShutdown Menu operation Functions available when receiving differentSignal types Menu systemMenu. Refer to p.34 for more details Using the menusImage adjustment and press 5 or 6 button to select Keystone Image adjustment menu Display setting menu Default setting menu Information menu Additional Information Cleaning the lensCleaning the projector case Care of the projectorAbout the lamp Replace the lamp when a sign appears on the screenWhen the lamp is broken Storing the projectorLamp warning message Replacing the lampDo not turn the power on with the lamp cover removed When the projector is in an abnormal state Indicator lightsWhen the projector is in a normal state State RemarkTroubleshooting Specifications Projector specificationsSupported signal format for Component-YPBPRInput DimensionsSignal timing Supported timing for PC inputSupported signals for Video and S-Video inputs EEC statement Regulation statementsFCC statement MIC statement
Top Page Image Contents