Toshiba TDP-P75 owner manual Adjusting the image, Adjusting the height, Auto-adjusting the image

English

Adjusting the image

Adjusting the height

The projector is equipped with 1 quick-release adjuster foot and 1 tilt adjuster foot. The adjusters can be used to change the image height and projection angle. To adjust the projector to your desired

image height and projection angle:

1.Lift the projector up to the desired

angle and press the front adjuster button to release the adjuster. The adjuster will drop into position.

2.Screw the tilt adjuster foot to fine tune the horizontal angle.

1

To retract the feet, hold up the projector while pressing the front adjuster button,

then slowly lower the projector. Screw the rear adjuster foot in a reverse direction.

If the screen and the projector are not perpendicular to each other, the projected image becomes vertically trapezoidal. To correct this situation, adjust the value of Keystone in the Picture menu, on the projector control panel or on the remote control.

Auto-adjusting the image

In some cases, you may need to optimize the picture quality. To do this, press the AUTO button on the control panel of the projector or on the remote control. Within 5 seconds, the built-in Intelligent Auto Adjustment function will re-adjust the values of Frequency, and Clock to provide the best picture quality.

This function is only available when the Computer input is selected.

The screen will be blank while the auto-adjustment is functioning.

Fine-tuning the image size and clarity

1. Adjust the projected image to	2. Then sharpen the image by
the size that you need using the	rotating the focus ring.
zoom ring.

Operation 27