Toshiba TDP-FF1A manual Using the remote control, Changing the new lithium battery

Page 22

Using the remote control

Changing the new lithium battery

Remove the battery compartment.  Replace the lithium battery.

Be sure to align the battery according to the polarity.

Insert the battery compartment.

Operating the remote control

Turn on the projector and then the remote control can be used to adjust the OSD, volume, and input select.

Note

•The remote control is shipped with a plastic sheet between the battery and its contact. Pull on the sheet to remove it from the remote control.

•Remove the battery from the remote control when it will not be used for an extended period.

Battery

•Before using the battery, please refer to the notes on .

•If the remote control stops working, or if its range decreases, replace the battery with new one.

The remote control

•The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or fluorescent lighting.

•Do not drop or bang it.

•Do not leave it in hot or humid locations.

•Do not get it wet or place on top of wet objects.

•Do not take it apart.

•In rare cases, ambient conditions could impede the operation of the remote control. If this happens, point the remote control at the main unit again, and repeat the operation.

22

Image 22

Contents LED Projector TDP-FF1A Safety Precautions USA onlyBefore Using Power Sources Ventilation Important Safety InstructionsSource of Light Heat Power-Cord ProtectionCleaning Water and MoistureObject and Liquid Entry Lightning stormsDo not place the product vertically Stack InhibitedDamage Requiring Service AccessoriesServicing Safety Check Replacement PartsDo not use the product in a closed installation state Important Precautions Save Original Packing MaterialsExemption Clauses Other Cautions and Informations Following information is only for EU-member statesBattery Type BatteriesTable of Contents Table of Contents Checking the package contents Bottom Main unit componentsTop Left17Rear RightFront Slideshow mode Normal modeFile view mode Control keypad and functionsRemote control keypad and functions Remote ControlRemove the battery Using the battery pack with the projectorInstalling the battery Charge the batterySpecifications for Toshiba Li-ion battery Battery capacity is less than 10%Operating the remote control Using the remote controlChanging the new lithium battery  Insert the battery compartmentProjection Distance and Size PlacementPlacement Styles Screen Top view Side viewConnection Before connectionTurning the power on and off Switching the power off OBasic operations Press the Autoset button on the remote control Using handy featuresUsing auto setting Only for computer input Press the remote control’s Keystone or buttonPress the Freeze button on the remote control Freezing the image FreezeUsing USB Memory File View ModeUsing USB Memory Slideshow About USB memory function ToshibaOperations Placement of the projection screen Using the screenUsing the menus How to use the menusImage adjustment menu Screen size Display setting menuLevel Lower HigherDefault setting menu Displaying Information Status display Lens cleaning Lens and main unit cleaningMain unit cleaning Before calling service personnel Indicators Than 10%List of general specifications SpecificationsSpecification List of supported signals RGB signals VGAList of supported signals Video signals List of supported signals Y/PB/PR signalsList of USB function limitations PB/PR input 0V p-p 75 Ω Signal PB/PR signals 7V p-p 75 Ω Pin assignment of Computer in terminalsPage 36.83Y03G001-A