Toshiba TDP-FF1A manual Using the menus, How to use the menus

Page 35

Using the menus

You can call up on-screen menus, and make adjustments and settings using the operation buttons on the control panel (main unit side) and remote control.

How to use the menus

The menu shown below is for operation instructions purposes and might differ from the actual display.

1. Press the MENU button for longer than 1 seconds. The Image adjustment menu appears.

2. Select a Category

Select a category by using . There are following 4 categories.

Image adjustment menu

Display setting menu Default setting menu

Status display menu

3. Adjustments & Settings

Press the button.

Displays the current adjustments and settings of the selected category.

Item shown with gray cannot be adjusted with the current input source.

Item

Adjustment/Setting Value

Push key to select item and

press button.

These marks signify that there are options.

Press to display a list of options.

The figure shows displays given for operation instructions purposes. As the display may differ depending on the item, use the following pages as a reference.

5.End

Press the MENU

button

The menu disappears.

Operations

4.Back

MENU button

35

Image 35

Contents LED Projector TDP-FF1A USA only Safety PrecautionsBefore Using Source of Light Important Safety InstructionsPower Sources Ventilation Water and Moisture Power-Cord ProtectionCleaning HeatStack Inhibited Lightning stormsDo not place the product vertically Object and Liquid EntryServicing AccessoriesDamage Requiring Service Do not use the product in a closed installation state Replacement PartsSafety Check Save Original Packing Materials Important PrecautionsExemption Clauses Following information is only for EU-member states Other Cautions and InformationsBatteries Battery TypeTable of Contents Table of Contents Checking the package contents Left Main unit componentsTop BottomFront Right17Rear Control keypad and functions Normal modeFile view mode Slideshow modeRemote Control Remote control keypad and functionsCharge the battery Using the battery pack with the projectorInstalling the battery Remove the batteryBattery capacity is less than 10% Specifications for Toshiba Li-ion battery Insert the battery compartment Using the remote controlChanging the new lithium battery Operating the remote controlScreen Top view Side view PlacementPlacement Styles Projection Distance and SizeBefore connection ConnectionSwitching the power off O Turning the power on and offBasic operations Press the remote control’s Keystone or button Using handy featuresUsing auto setting Only for computer input Press the Autoset button on the remote controlFreezing the image Freeze Press the Freeze button on the remote controlFile View Mode Using USB MemoryUsing USB Memory Slideshow Toshiba About USB memory functionOperations Using the screen Placement of the projection screenHow to use the menus Using the menusImage adjustment menu Lower Higher Display setting menuLevel Screen sizeDefault setting menu Displaying Information Status display Main unit cleaning Lens and main unit cleaningLens cleaning Before calling service personnel Than 10% IndicatorsSpecification SpecificationsList of general specifications VGA List of supported signals RGB signalsList of USB function limitations List of supported signals Y/PB/PR signalsList of supported signals Video signals Pin assignment of Computer in terminals PB/PR input 0V p-p 75 Ω Signal PB/PR signals 7V p-p 75 ΩPage 36.83Y03G001-A