Toshiba TDP-FF1A Placement Styles, Projection Distance and Size, Screen Top view Side view

Page 23

Placement

Placement Styles

The factory setting is “floor-mounted front projection.” Set the [Projection mode] in the

Default setting menu , in accordance with your needs.

Warning

•Always observe the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit.

Projection Distance and Size

Use the figures, tables, and formulas below to determine the projection size and projection distance. (Projection sizes are approximate values for full-size picture with no keystone adjustment.)

Screen Top view

Side view

Lens center

a (min length) =		projection size (inches)
a (min length) =			27.3403
			27.3403
	FF1 uses a fixed lens.

		projection		projection	height (H)
		size (inches)		distance (m)	(cm)
		11		0.40	1.7
		17		0.62	2.6
		25		0.91	3.8
		30		1.10	4.6
		35		1.28	5.3
		40		1.46	6.1
		45		1.65	6.9
		50		1.83	7.6
		60		2.19	9.1
		68		2.49	10.4

Note: 110% offset condition

Preparations

a is the distance (m) between the lens and the screen, and corresponds to a range of 0.4 m to 2.5 m. H is the height from the image bottom to the center of the lens.

23

Image 23

Contents LED Projector TDP-FF1A USA only Safety PrecautionsBefore Using Source of Light Important Safety InstructionsPower Sources Ventilation Water and Moisture Power-Cord ProtectionCleaning HeatStack Inhibited Lightning stormsDo not place the product vertically Object and Liquid EntryServicing AccessoriesDamage Requiring Service Do not use the product in a closed installation state Replacement PartsSafety Check Save Original Packing Materials Important PrecautionsExemption Clauses Following information is only for EU-member states Other Cautions and InformationsBatteries Battery TypeTable of Contents Table of Contents Checking the package contents Left Main unit componentsTop BottomFront Right17Rear Control keypad and functions Normal modeFile view mode Slideshow modeRemote Control Remote control keypad and functionsCharge the battery Using the battery pack with the projectorInstalling the battery Remove the batteryBattery capacity is less than 10% Specifications for Toshiba Li-ion battery Insert the battery compartment Using the remote controlChanging the new lithium battery Operating the remote controlScreen Top view Side view PlacementPlacement Styles Projection Distance and SizeBefore connection ConnectionSwitching the power off O Turning the power on and offBasic operations Press the remote control’s Keystone or button Using handy featuresUsing auto setting Only for computer input Press the Autoset button on the remote controlFreezing the image Freeze Press the Freeze button on the remote controlFile View Mode Using USB MemoryUsing USB Memory Slideshow Toshiba About USB memory functionOperations Using the screen Placement of the projection screenHow to use the menus Using the menusImage adjustment menu Lower Higher Display setting menuLevel Screen sizeDefault setting menu Displaying Information Status display Main unit cleaning Lens and main unit cleaningLens cleaning Before calling service personnel Than 10% IndicatorsSpecification SpecificationsList of general specifications VGA List of supported signals RGB signalsList of USB function limitations List of supported signals Y/PB/PR signalsList of supported signals Video signals Pin assignment of Computer in terminals PB/PR input 0V p-p 75 Ω Signal PB/PR signals 7V p-p 75 ΩPage 36.83Y03G001-A