LABEL LOCATIONS
CAUTION Label
MODEL NO. / | SERIAL NO. Label | |
RATING Label | ||
|
| MANUFACTURED; |
| 3.3A | WARNING Label |
|
| SERIAL NO. |
3.3 | 1.5A |
|
CAUTION Label | WARNING Label | |
| T NAF |
|
|
|
| PMALMPE |
|
| OTUA |
ON | - | .LOV | ETS |
|
| .LVO |
|
| TYSKE |
|
|
| ENO TUA | |
| + |
|
| O |
| UNME |
|
|
|
|
| ON | TUNPI | |
| DBY /STAN |
|
| |
CAUTION Label (LED)
CAUTION Label (LASER) |
|
|
Remote Control | Models with Document Camera | |
| PLAY |
|
| INPUT |
|
| LASER WARNING | CAUTION Label |
CAUTION Label (LASER)
Models with Document Camera
POWER SUPPLY CORD SELECTION
If your line voltage is 220 to 240V, use one of the following types of cable. |
| Using | |||
Plug |
| Plug |
| ||
configuration Plug type | Line voltage | configuration Plug type | Line voltage |
| |
EURO | 220 – 240V | Australian | 200 – 240V | Before | |
Switzerland | 200 – 240V | ||||
|
| ||||
|
| 240V |
|
| |
|
| 10A |
|
| |
UK | 220 – 240V | 240V |
|
| |
|
| 6A |
|
| |
Use a 5A fuse which is approved by ASTA | North American | 200 – 240V |
| ||
or BSI to BSI362. |
|
| |||
Always replace the fuse cover after | 240V | |
15A | ||
changing the fuse. | ||
|
IMPORTANT PRECAUTIONS
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to ship your LCD projector. For maximum protection, repack the set as it was originally packed at the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm location. When the unit is exposed to such a change in temperature, moisture may condense on the crucial internal parts. To prevent the unit from possible damage, do not use the unit for at least 2 hours when there is an extreme or sudden change in temperature.
Place and Manner of Installation
•Do not place in hot locations, such as near heating equipment. Doing so could cause malfunction, and shorten the life of the LCD panel.
•Avoid locations with oil or cigarette smoke. Doing so will dirty the LCD panel and other optical parts, shortening their lives, and darkening the screen.
•Do not use in angle of 20° or more degrees. Doing so could shorten the life of the lamp.
•If used at high altitudes, the unit could cease operation even if used within the rated temperature range. This is because the thinner air at high altitudes decreases the internal cooling efficiency. Therefore, please lower the ambient temperature if using at high altitudes.
8 | 9 |