Toshiba TLPX10E owner manual Press Camera Gain +/- to improve view of a, Camera in reverse

Picture projection with the document imaging camera (continued)

CONTENTS 78

W.BALANCE STORE IMAGE ARM LIGHT

LOCK

CAMERACAMERA

GAIN

6

Camera control panel

6	GAIN	Press CAMERA GAIN (+/-) to improve view of a
	CAMERA	camera subject which is too dark or vivid.

Notes

•You can adjust the “Sharpness” of the camera image on the menu screen. 54

•If the image flickers due to a fluorescent light in the room, either turn off the fluorescent light or

set the “Shutter” from the menu screen. 54

Note that the image may still flicker due to the lighting, the document status, the image adjustment, etc., even if the “Shutter” setting is changed.

	7	When finished, turn off the light and close it,
		and put back the arm.
		Follow the steps of “Preparation of the document imaging
			imagingcamera	Document
		camera” in reverse.
	Notes
•	Though this projector uses a 1.45 million pixel camera unit, the images projected on the
	screen are 1024 x 768 dot images. If the “Screen size” in the menu screen 54 is set to
	“Full”, the camera’s full image is compressed to 1024 x 768 dots. If “Thru” is selected, the
	1024 x 768 dots at the center of the image are projected.
•	The light turns off automatically when the arm is leaned.
•	When the arm is not raised up, the camera source cannot be projected.
•	In the camera input selected, audio signals are not output.