Toshiba TDP-T420 owner manual Using the menus, How to set password from Off to On

Using handy features (Continued)

How to set password (from [Off] to [On])

		Select [Password] in the Default setting 2 menu and press the or
1
		button.
		Select [Password setting] next, and press the or button.
	2
		Select [On].
3
		Select [OK] and press the button.
4
		The password entry screen is displayed.

Using the menus

You can call up on-screen menus, and conduct a number of adjustments and settings using the operation buttons p.16 on the control panel (main unit side) and remote control.

Setup using the Setting display

The menu shown below is for operation instructions purposes and might differ from the actual display.

1.Press the MENU button Display the Setting display menu.

2.Select a Category

	Enter the password using numeric keys of the remote control.
5
	The password setting will be set as [On].
6

How to operate when password is [On]

	Turn on the power.
1
	The lamp lights and the password entry screen appears.
2
	Enter the password using numeric keys of the remote control.
3
	If the entered password is correct, the start-up screen appears and the projector
	goes into normal operation. If the password is wrong, a message appears to prompt
	you to re-enter the password, and again the password entry screen is displayed. If
	you enter a wrong password for more than 5 times, the projector will automatically

Select a category by using . There are following 6 categories:

Image adjustment menu p.36

Position adjustment menu p.37

Display setting menu	p.38
Default setting 1 menu	p.41
Default setting 2 menu	p.42
Status display menu	p.43

Displays the current adjustments and settings of selected category.

Item shown with gray cannot be adjusted with the current input source.

power off and enter standby mode.

Note

•When the password setting is [On], the password will be enabled only when the power is turned on for the first time after the main power switch has been on. The password function will not be activated if the power backed on while it is standby mode without turning off the main power switch.

How to set password (from [On] to [Off])

1Select [Password] in the Default setting 2 menu and press the or button.

The password entry screen is displayed.

2Enter the password using numeric keys of the remote control.

3Select [Password setting] next, and press the or button.

4Select [OFF].

5Select [OK] and press the button.

3. Adjustments & Settings Press			or	to open the menu.				Operations
		Item
		Adjustment/Setting Value
	These marks signify
	the items can be		These marks			These marks signify
	adjusted/set by using
			signify that there			that there are setting
	.
			are options.			screens. Press		or
			Press	or			to display a list of
			to display a list of
						setting screens.
			options.
These marks signify the items can						* When no item is
be selected from the list by using						changed, press		.
.
After an item is selected, apply it by			Toggle items with		.
pressing	.		Select items with			and press	.
			Fix selection with		.

•The figure shows displays given for operation instructions purposes. As the display may differ depending on the item, refer to the following applicable pages for the menu item you desire.

•To return to previous item, press the RETURN button.

4. End Press the MENU button once more.

(The menu will disappear automatically after 30 seconds, if no operation is conducted.)

34 35