Toshiba Network Camera, IK-WP41A quick start Install to the mounting bracket, Wall Mount JK-WM41A

2. Install to the mounting bracket

IK-WP41A supports several mounting brackets like pendant mount, wall mount, etc. Select an appropriate bracket according to your location, and purchase separately.

Here are major instance of installation. For more information about accessories, visit www.toshibasecurity.com.

2.1 Wall Mount (JK-WM41A)

A)Drill 4 holes on the wall matching the mount holes on the plate. Diameter φ3/8” (9.5mm), depth 1/1/2” (39mm).

B)Hammer 4 anchor bolts(not supplied) into the holes and secure them. (1) of Figure 1

C)Secure the connector ring of the accessory to this bracket in the clockwise direction. (2) of Figure 1

D)Secure the safety wire to the screw hole on the back side of bracket. You need to fix the wire with appropriate M4 screw and washer (not supplied). (3) of Figure 1

E)Remove the original connector ring of the camera, and thread the cabling of the camera through the short aluminum tube and push the cables out to the wall. (4) of Figure 1

F)Secure this bracket to the wall with hex nuts and wrench (not supplied). (5) of Figure 1

G)Connect the camera to the connector ring in the clockwise direction. (Figure 2)

H)Use torx wrench to secure the attached fixing screw 1 to the connector ring. Use allen wrench to secure the fixing screw to the bracket. This allen wrench is supplied in the bracket (Figure 3)

I)Installation completed.(Figure 4)

NOTE:

￿When drilling the hole, please make sure the wall thickness is greater than 50mm in order to maintain its structural integrity.

Warning:

￿The safety wire must be connected to the camera and wall mount bracket. This will avoid personal hazards if the unit falls from its installation. When installing the camera, please secure the safety wire to the screw holes on the bracket.

￿Make sure there are no damaged parts during assembly.

12