Toshiba B-SV4T owner manual Connecting the Power Adapter and the Power Cord

Page 15

2. PRINTER SETUP

ENGLISH VERSION EO1-33062

2.5 Connecting the Power Adapter and the Power Cord

2.5Connecting the Power Adapter and the Power Cord

NOTES:

1.Since the power cord is not enclosed in this printer, please purchase a proper one after referring to page 1-2.

2.The EA10953 AC adapter should be exclusively used for the B-SV4T Series printer. The B-SV4T Series printer must be powered by the EA10953 AC adapter.

1.Make sure that the printer power switch is in the OFF (O) position.

2.Insert the Power Cord into the inlet of the Power Adapter.

Power Cord

 

 

 

Power Adapter

 

 

 

 

 

 

 

 

 

3.Insert the Power Adapter connector into the Power Jack on the rear of the printer.

Power Jack

Power Adapter

Connector

4.Plug the other end of the Power Cord into a grounded outlet as shown in the figure below.

E2- 4

Image 15
Contents SV4T Series SV4T Series Waste Recycling information for users CE Compliance for EU onlyMeanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents Glossaries Index EA2-1Product Overview Introduction Features Unpacking AccessoriesSVT H05VV-F When purchasing the power cordDimensions Front ViewRear View Interior Button and Indicator LampPrecautions Printer SetupProcedure before Operation Turning the PrinterTurning on the Printer Turning OFF the Printer Connecting the Cables to the PrinterConnecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Opening/Closing the Top CoverLoading the Media Manually adjust the Media Guide position to the media width Calibration Batch modeHow to set the media Strip mode OptionCut mode Option External Media Roll Hanger Option Loading the Ribbon Paper Core Ribbon Roll Print Head Media Sensor Calibration Test, and Dump Mode different type UtilitiesSelf Print Test and Dump Mode Media SensorProgram Version VX.XX Print test label sampleMaintenance CleaningPrint Head Cover Platen/SensorsCare/Handling of the Media and Ribbon Troubleshooting Troubleshooting GuideRemoving Jammed Media A1.1 Printer Appendix 1 SpecificationsLabel A1.2 OptionsA1.3 Media A1.3.1 Media TypeA1.3.2 Detection Area of the Transmissive Sensor A1.3.3 Detection Area of the Reflective Sensor Black MarkRectangular/Oval Hole A1.3.4 Effective Print Area A1.4 RibbonInterface Cables Appendix 2 InterfaceBar code GlossariesSupply Index Index EO1-33062