Toshiba B-SV4T owner manual Opening/Closing the Top Cover, To open the Top Cover

Page 16

2. PRINTER SETUP

ENGLISH VERSION EO1-33062

2.6 Opening/Closing the Top Cover

2.6Opening/Closing the Top Cover

WARNING!

1.To avoid injury, be careful not to trap your fingers while opening or closing the cover.

2.When closing the Top Cover, do not place your hands or fingers between the Top Cover and the Lower Cover. The Top Cover may free-fall, which may cause injury.

CAUTION!

1.Be careful not to touch the Print Head Element when opening the Top Cover.

Failure to do this may cause missing dots by static electricity or other print quality problems.

2.Do not forcibly close the Top Cover while it is held at Position 1 or Position 2. Doing this could damage the Top Cover Support.

When opening or closing the Top Cover, please be sure to follow the instructions below.

To open the Top Cover:

1.Turn the Cover Open Levers frontward, and gradually open the Top Cover.

Top Cover

Cover Open Lever

Cover Open Lever

There are four positions for the Top Cover: OPEN position, Position 1, Position 2, and CLOSE position. The Top Cover can be held at Position 1 or Position 2.

OPEN position

OPEN

Position 2

2

Position 1

1

CLOSE position

CLOSE

To hold the Top Cover at Position 1, fist open the Top Cover until the Top Cover Support goes over Position 1 (c), then close the Top Cover a little (d) to secure the Top Cover Support.

Top Cover Support

Position 1

E2- 5

Page 15 Page 17
Image 16
Page 15 Page 17
Contents SV4T Series SV4T Series CE Compliance for EU only Waste Recycling information for usersSafety Summary Meanings of Each SymbolPrecautions Request Regarding MaintenanceTable of Contents EA2-1 Glossaries IndexIntroduction Features Unpacking Accessories Product OverviewWhen purchasing the power cord SVT H05VV-FFront View DimensionsRear View Button and Indicator Lamp InteriorPrinter Setup PrecautionsTurning the Printer Procedure before OperationTurning on the Printer Connecting the Cables to the Printer Turning OFF the PrinterConnecting the Power Adapter and the Power Cord Opening/Closing the Top Cover To open the Top CoverOpening/Closing the Top Cover To close the Top CoverLoading the Media Manually adjust the Media Guide position to the media width Batch mode CalibrationStrip mode Option How to set the mediaCut mode Option External Media Roll Hanger Option Loading the Ribbon Paper Core Ribbon Roll Print Head Test, and Dump Mode different type Utilities Self Print Test and Dump ModeMedia Sensor Media Sensor CalibrationPrint test label sample Program Version VX.XXCleaning MaintenancePrint Head Platen/Sensors CoverCare/Handling of the Media and Ribbon Troubleshooting Guide TroubleshootingRemoving Jammed Media Appendix 1 Specifications A1.1 PrinterA1.2 Options A1.3 MediaA1.3.1 Media Type LabelA1.3.2 Detection Area of the Transmissive Sensor Black Mark A1.3.3 Detection Area of the Reflective SensorRectangular/Oval Hole A1.4 Ribbon A1.3.4 Effective Print AreaAppendix 2 Interface Interface CablesGlossaries Bar codeSupply Index Index EO1-33062
Top Page Image Contents