Toshiba B-SV4T owner manual External Media Roll Hanger Option

Page 23
3”-Diameter Media Shaft (Option)

2. PRINTER SETUP

ENGLISH VERSION EO1-33062

2.7 Loading the Media

2.7Loading the Media (Cont.)

When a media roll has an outside diameter exceeding 127 mm (5) or an inner core diameter of 38.1 mm (1.5), the optional External Media Roll Hanger is required.

1.Fit the protrusions on the bottom of the printer into the holes in the External Media Roll Hanger.

External Media Roll

Hanger (Option)

2.Load a media roll onto the printers Media Holder Assy, and place it into the cuts of the External Media Roll Hanger.

3.Pull the media forward and insert the leading edge into the printer so that it passes between the Rear Media Guides.

4.Manually move the Rear Media Guides so that the media is centred.

Rear Media Guides

Media Holder

Ass’y

External Media

Roll Hanger

When the media roll has the inner core diameter of 76.2 mm (3”), use the 3”-Diameter Media Shaft supplied with the optional External Media Roll Hanger.

5.Refer to the previous pages to complete the media loading.

6.Close the Top Cover.

E2-12

Image 23
Contents SV4T Series SV4T Series Waste Recycling information for users CE Compliance for EU onlyMeanings of Each Symbol Safety SummaryRequest Regarding Maintenance PrecautionsTable of Contents Glossaries Index EA2-1Product Overview Introduction Features Unpacking AccessoriesSVT H05VV-F When purchasing the power cordRear View DimensionsFront View Interior Button and Indicator LampPrecautions Printer SetupTurning on the Printer Procedure before OperationTurning the Printer Turning OFF the Printer Connecting the Cables to the PrinterConnecting the Power Adapter and the Power Cord To open the Top Cover Opening/Closing the Top CoverTo close the Top Cover Opening/Closing the Top CoverLoading the Media Manually adjust the Media Guide position to the media width Calibration Batch modeHow to set the media Strip mode OptionCut mode Option External Media Roll Hanger Option Loading the Ribbon Paper Core Ribbon Roll Print Head Media Sensor Calibration Test, and Dump Mode different type UtilitiesSelf Print Test and Dump Mode Media SensorProgram Version VX.XX Print test label samplePrint Head MaintenanceCleaning Cover Platen/SensorsCare/Handling of the Media and Ribbon Removing Jammed Media TroubleshootingTroubleshooting Guide A1.1 Printer Appendix 1 SpecificationsLabel A1.2 OptionsA1.3 Media A1.3.1 Media TypeA1.3.2 Detection Area of the Transmissive Sensor Rectangular/Oval Hole A1.3.3 Detection Area of the Reflective SensorBlack Mark A1.3.4 Effective Print Area A1.4 RibbonInterface Cables Appendix 2 InterfaceBar code GlossariesSupply Index Index EO1-33062