Toshiba B-SV4D owner manual Strip mode Option

Page 17

2. PRINTER SETUP

ENGLISH VERSION EO1-33061

2.6 Loading the Media

2.6Loading the Media (Cont.)

Strip mode (Option):

When issued in the strip mode, labels are automatically removed from the backing paper each time a label is printed.

How to set the media

When issuing labels in the strip mode, set the label in the following procedure:

1.Open the Strip Block by the tabs on both sides.

Tab

Strip Block

NOTE:

When the media is correctly set, the backing paper is supposed to be

2.Remove enough labels from the leading edge of the media to leave about 200 mm of backing paper free.

3.Pass the backing paper over the Platen and the Strip Plate, and insert the leading edge of the backing paper into the Backing Paper Outlet.

Strip Feed Roller

pinched by the Platen and the Strip Feed Roller as shown below.

Strip Plate

Label

Strip Feed Roller

Platen

Backing Paper

Platen

Strip Plate

Strip Block

Backing Paper

4. Close the Strip Block.

Cut mode:

Backing Paper Outlet

WARNING!

1.When attaching or removing the cutter cover, be sure to turn off the power. Otherwise, you may be injured.

2.The cutter is sharp, so care must be taken not to injure yourself when handling the cutter.

CAUTION!

1.Be sure to cut the backing paper of the label. Cutting labels will cause the glue to stick to the cutter which may affect the cutter quality and shorten the cutter life.

2.Use of tag paper when the thickness exceeds the specified value may affect the cutter life.

When the Cutter is fitted, the media is automatically cut.

After loading the media as described on the previous pages, insert the leading edge of the media into the Media Outlet of the Cutter.

Media Outlet

Cutter Cover

E2- 7

Image 17
Contents SV4D Series Vorsicht CE Compliance for EU onlySV4D Series Meanings of Each Symbol Safety SummaryPrecautions Table of Contents Product Overview Introduction Features UnpackingAccessories SVT H05VV-F When purchasing the power cordFront View Rear View DimensionsAppearance Interior Button and Indicator LampPrecautions Printer SetupTurning on the Printer Procedure before OperationTurning the Printer Turning OFF the Printer Connecting the Cables to the PrinterConnecting the Power Adapter and the Power Cord Loading the Media Media Guide Adjustment Knob Strip mode Option External Media Roll Hanger Option Self Print Test and Dump Mode Test, and Dump Mode different type UtilitiesMedia Sensor Media Sensor CalibrationPrint test label sample E2-11 Print Head MaintenanceCleaning Cover Platen/SensorsCare/Handling of the Media Removing Jammed Media TroubleshootingTroubleshooting Guide A1.1 Printer Appendix 1 SpecificationsA1.3.1 Media Type A1.2 OptionsA1.3 Media A1.3.3 Detection Area of the Reflective Sensor A1.3.2 Detection Area of the Transmissive SensorFigure below shows the effective print area on the media A1.3.4 Effective Print AreaInterface Cables Appendix 2 InterfaceBar code GlossariesIndex Index EO1-33061A
Related manuals
Manual 31 pages 27.26 Kb