Toshiba B-SV4D owner manual A1.3.2 Detection Area of the Transmissive Sensor

APPENDIX 1 SPECIFICATIONS

ENGLISH VERSION EO1-33061

A1.3 Media

A1.3.1 Media Type (Cont.)

				Unit: mm (inch)
Issue mode	Batch mode		Strip mode	Cut mode
Item
c Width including backing paper	25.4 to 112 (1.0 to 4.4)
d Media width			Min. 17 (0.7)
e Media pitch	10 to 609 (0.39 to 24.0)		15 to 609 (0.59 to 24.0)
f Media length	Min. 10 (0.39)		Min. 15 (0.59)
g Gap length (or black mark length)	Min. 2			Min. 6
h Black mark width			Min. 8
Thickness			0.06 to 0.19
Max. outer roll diameter			Ø127 (5)
	Ø214 (8.4): When the optional External Media Roll Hanger is used.
Roll direction		Either is acceptable.
	Outside roll media; Linerless paper (option)
Inner core diameter	25.4, 38.1, or 76.2 (1, 1.5, or 3) (See NOTE 2.)

NOTES:

1.To ensure print quality and print head life use only TOSHIBA TEC approved media.

2.When using a media roll of 76.2-mm (3”) inner core diameter, the 3”-Diameter Media Shaft included in the optional External Media Roll Hanger is required.

A1.3.2 Detection Area of the Transmissive Sensor

The Transmissive Sensor is positioned 6 mm from the centre.

The Transmissive Sensor detects a gap between labels, as illustrated below.

Centre of media

Area to be detected.

Sensor position

Label

Sensor position

Print side

Min. 2 mm		Gap
(Min. 6 mm:		Label
cut mode)
	Min. 8 mm

6 mm

A1.3.3 Detection Area of the Reflective Sensor

Media feed direction

The Reflective Sensor is movable within the full range of the media width.

The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm. The Reflective Sensor should be aligned with the centre of the Black Mark.

Sensor should be positioned at the centre of the black mark.

Min. 2 mm (Min. 6 mm:

Cut mode)

Min. 8 mm

Detecting the black marks on the back.

Media feed direction

Sensor is movable within the full range.

EA1- 3