Toshiba B-450-QQ owner manual Guide Wheel

Page 13

7. LOADING THE RIBBON

EO1-33006

7. LOADING THE RIBBON

5. Set the ribbon core (supply side) by fitting the protrusion into the notch.

Fig. 7-3

6. Turn the guide wheel in the arrow-indicating direction to remove any slack of the ribbon.

NOTE: Make sure that the ribbon has no wrinkles and the protrusions are fitted into the notches of the ribbon cores.

Guide Wheel

Fig. 7-4

7-2

Image 13

Contents QQ Series Safety Summary Request Regarding Maintenance PrecautionsTable of Contents Introduction AccessoriesApplicable Model 5 2 T S 1 0 Q QGeneral Specifications SpecificationsPrinting Specifications MSI, ITF, NW-7, CODE39, CODE93, CODE128Ribbon Specificatins Paper LABEL/TAG SpecificationsOption FRONT/REAR View AppearanceOperation Panel DIP SW DIP Switch FunctionsSetting UP the Printer SET UP ProcedureRequirements for Operation DB-9SInstalling the Supply Holder Unit Installation ProcedureConnecting the Power Cord and Cables Loading the Ribbon Guide Wheel Loading the Paper Page Batch type Pause Threshold SettingCARE/HANDLING of the Paper and Ribbon Cleaning General MaintenanceCovers Removing Jammed Paper Cleaning the Cutter UnitAssembling is reverse order of removal Error type Problem Solution TroubleshootingProblem Solution Cutter ErrorAppendix Power LED Error LEDIndex ON-LINE LED