Toshiba B-450-HS-QQ owner manual Installation Procedure, Installing the Supply Holder Unit

Page 12

6. INSTALLATION PROCEDURE

EO1-33019

6.1 INSTALLING THE SUPPLY HOLDER UNIT

6. INSTALLATION PROCEDURE

6.1 INSTALLING THE SUPPLY HOLDER UNIT

WARNING!

Turn the power OFF before installing the supply holder unit.

Fit the two studs on the bottom of the printer into the holes in the supply holder unit.

Supply Holder Unit

Fig. 6-1

6.2 INSTALLING THE SUPPLY COVER

Fit both hooks of the supply cover onto the shafts of the supply holder, and then gently close the supply cover. (Refer to Fig. 6-2)

NOTE: After this section, the supply cover will be removed in photos and figures. Please understand that it provides clearer descriptions.

Supply Cover

Hook

Shaft

Fig. 6-2

6-1

Image 12

Contents HS-QQ Series Page Safety Summary Precautions Request Regarding MaintenanceTable of Contents Accessories IntroductionApplicable Model 5 2 H S 1 2 Q QSpecifications General SpecificationsPrinting Specifications Ribbon Specifications OptionAppearance FRONT/REAR ViewOperation Panel DIP Switch Functions Turn the Power OFF before changing the DIP switchesSET UP Procedure Setting UP the PrinterRequirements for Operation Installation Procedure Installing the Supply Holder UnitInstalling the Supply Cover Connecting the Power Cord and Cables Loading the Ribbon Guide Wheel Loading the Paper Page Loading the Paper Strip type Setting the black mark sensor position Setting the feed gap sensor position Threshold Setting PauseCARE/HANDLING of the Paper and Ribbon General Maintenance CleaningCovers Cleaning the Cutter Unit Removing Jammed PaperCleaning the Strip Unit Troubleshooting Error type Problem SolutionHead Error Problem SolutionAppendix Index ON-LINE LEDPage