Setting the black mark sensor position

8. LOADING THE PAPER

EO1-330019

8. LOADING THE PAPER

■Setting the black mark sensor position

1Fold over the end of the label. Then, move sensor knob A in a the horizontal direction so that the mark on the sensor cover aligns with the black mark. Remember the number that centre of the sensor knob A is positioned at. Set the sensor knob B to the same position number.

Black Mark

1 2 3 4 5

Sensor knob A

Black Mark Sensor Position	Fig. 8-12
Sensor Cover

2Release the lock lever in the direction indicated by the arrow, and gently lift the sensor cover. NOTE: Lift the sensor cover gently so that it does not touch the ribbon.

3Set sensor knob B to the same position number as the sensor knob A.

NOTE: The sensor knobs A and B are set to the position #3 where the black mark is centred in the label width as a default. Do not change the position of sensor knobs A and B except when changing the sensor detecting position. Be sure to set sensor knobs A and B to the same position #. Failure to do this may cause a paper feed error and paper end detecting error.

Sensor Knob B

1 2 3 4 5

Fig. 8-13

4Draw the label onto the platen. Close the sensor cover and return the lock lever to lock the sensor cover tight.

8-5