2. APPEARANCE
2.1 Standard Model
1)Power LED (Green)
This is the LED to indicate the power ON/OFF status of the POS terminal. The green LED is illuminated when the power is ON.
2)HDD LED (Yellow)
The yellow LED is illuminated during the access to the hard disk drive.
3)Power Switch
This is the switch to turn the power of the POS terminal ON or OFF.
4)Reset Switch
This switch is used to reset the unit when the POS terminal hangs up.
CAUTION!
Do not press the Reset Switch unnecessarily. Doing so may cause an error.
5)Speaker Volume
This is used to adjust the internal speaker volume.
6)MIC IN
This connector is used to connect a monophonic microphone via the mono mini jack terminal.
7)Beep Volume
This is used to adjust the internal beep speaker volume.
8)Brightness Control
This is used to adjust the brightness of the operator’s display.
2- 2