Toshiba 281C, 451C, 351C manual 06/08

Error code	Classification	Contents	Troubleshooting
E550	Other paper jam	Paper remaining jam on the transport path: The	P. 5-19
		paper is remaining on the transport path when print-
		ing is finished (caused by a multiple paper feeding).
E712	RADF jam	Jam not reaching the original registration sensor:	P. 5-24
		The original fed from the original feeding tray does
		not reach the original registration sensor.
E713		Cover open jam in the read ready status: Jam	P. 5-24
		caused by opening of the RADF jam access cover
		or front cover while the RADF is waiting for the
		scanning start signal from the equipment.
E714		Feed signal reception jam: The feed signal is	P. 5-25
		received even no original exists on the original
		feeding tray.
E721		Jam not reaching the read sensor: The original	P. 5-25
		does not reach the read sensor after it has passed
		the registration sensor (when scanning obverse
		side) or the reverse sensor (when scanning reverse
		side).
E722		Jam not reaching the original exit/reverse sensor	P. 5-26
		(during scanning): The original which passed the
		read sensor does not reach the original exit/reverse
		sensor when it is transported from the scanning
		section to exit section.
E724		Stop jam at the original registration sensor: The	P. 5-26
		trailing edge of the original does not pass the origi-
		nal registration sensor after its leading edge has
		reached this sensor.
E725		Stop jam at the read sensor: The trailing edge of the	P. 5-27
		original does not pass the read sensor after its lead-
		ing edge has reached this sensor.
E731		Stop jam at the original exit/reverse sensor: The	P. 5-27
		trailing edge of the original does not pass the origi-
		nal exit/reverse sensor after its leading edge has
		reached this sensor.
E860		RADF jam access cover open: The RADF jam	P. 5-27
		access cover has opened during RADF operation.
E870		RADF open jam: RADF has opened during RADF	P. 5-28
		operation.
E910	Finisher jam	Jam at the bridge unit transport sensor 1: The	P. 5-29
	(Bridge unit)	paper does not reach the bridge unit transport sen-
		sor 1 after it has passed the exit sensor.
E920		Stop jam at the bridge unit transport sensor 1: The	P. 5-29
		trailing edge of the paper does not pass the bridge
		unit transport sensor 1 after its leading edge has
		reached the sensor.
E930		Jam at the bridge unit transport sensor 2: The trail-	P. 5-29
		ing edge of the paper does not reach the bridge unit
		transport sensor 2 after its leading edge has
		reached the bridge unit transport sensor 1.
E940		Stop jam at the bridge unit transport sensor 2: The	P. 5-29
		trailing edge of the paper does not pass the bridge
		unit transport sensor 2 after its leading edge has
		reached the bridge unit transport sensor 2.
E9F0	Finisher jam	Punching jam: Punching is not performed properly.	P. 5-46
	(Punch unit)	[MJ-1023/1024 (when MJ-6004 is installed)]
		[MJ-1101 (when MJ-6101 is installed)]

e-STUDIO281c/351c/451c ERROR CODE AND SELF-DIAGNOSTIC MODE © June 2005 TOSHIBA TEC

2 - 4

06/08