Toshiba user manual Drive Connectors SD-R1002

Page 15

DRIVE CONNECTORS – SD-R1002

Figure 1.SD-R1002 Combo Drive Rear Panel - Connectors

Power

Power is supplied to your CD-RW/DVD drive by the connection with your computer's

Connector

+5V/+12V power cable to the power socket at the back of drive. One side of the plug has

 

chamfered edges, so the power connector fits only one way

CAUTION: Severe damage to the Drive circuits may occur if power cable is plugged in upside-down with power ON

Audio

Supplies Analog and Digital sound to your system.

Connectors

 

ATAPI

The SD-R1002 DVD drive is connected to your computer system through the ATAPI

Connector

connector

Mode

The mode select jumpers are 6 straight angle pins located on the rear of the DVD drive.

Select

By placing a jumper on the pins, you can select the following functions: CL (CSEL), SL

Jumper

(Slave) or MA (Master). (see Setup for additional information).

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents CD-RW/DVD-ROM Combo Drive Contents Introduction SD-R1002 Types of Disc Formats Supported WriteTypes of Disc Formats Supported Read Load/Unload Button Front PanelLoading Tray LEDsJumper Settings Setup SD-R1002Placing Combo Drive inside your Computer Connecting CablesCompleting Installation Installing Audio CableInserting a Disc Vertically Drive Operation Inserting a Disc HorizontallyRemoving a Disc SoftwareUsage Guidelines Cleaning Media Emergency EjectionHandling Media Solution Troubleshooting SD-R1002Performance Specifications SD-R1002Environmental ReliabilityRegulatory PowerConnectors PhysicalDrive Connectors SD-R1002 Interface Pin Assignments
Top Page Image Contents