BATTERY CHARGING
B
A
Charger
Connector
• Plug the charger connector into the battery A .
•Plug the charger into a standard wall outlet B .
Notes:
-If power flow to the wall outlet is controlled by a switch, make sure the switch is “ON”.
-Use the charger only in a wall outlet. Do not plug the charger into a ceiling outlet.
•Before
•Recharge the battery for at least 14 hours after each use of your vehicle. Do not charge the battery longer than 30 hours.
•Once the battery is charged, disconnect the battery connector from the charger connector. Unplug the charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the Battery Installation section on page 18 for detailed instructions on installing your battery. If your battery is already installed in your vehicle, simply
ASSEMBLY
WARNING
Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery,
or help in assembly of the vehicle.
CAUTION
In the unassembled state, this package contains small parts. Adult assembly is required.
Bumper Support
1 | BOTTOM VIEW |
|
•Place the vehicle upside down.
•Slide the bumper support, ribbed side up, into the slot in the front end of the vehicle.
•Insert two 1/4" x 11/4" screws into the bumper support and tighten.
8 | |
|
|
