Dell T1650 owner manual Installing the Hard Drive, Removing the Optical Drive

Page 13

5.Flex the hard-drive bracket and remove the hard drive from the bracket.

6.Repeat the steps 3 to 5 to remove the second hard drive, if available.

Installing the Hard Drive

1.Insert the hard drive into the hard-drive bracket.

2.Press both the securing tabs inward and slide the hard-drive bracket into the bay.

3.Connect the data and power cables to the back of the hard drive.

4.Install the cover.

5.Follow the procedures in After Working Inside Your Computer.

Removing the Optical Drive

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a)cover

b)front panel

3.Disconnect the data cable and the power cables from the back of the optical drive.

Image 13

Contents Regulatory Model D09M Regulatory Type D09M004 Dell Inc Contents Diagnostics System SetupTroubleshooting Your Computer Technical Specifications Contacting DellBefore Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerInstalling the Cover Removing and Installing ComponentsRecommended Tools Removing the CoverInstalling the Intrusion Switch Removing the Intrusion SwitchRemoving the Front Panel Install the cover Removing the Expansion Card Installing the Front PanelInstalling the Memory Installing the Expansion CardMemory Module Guidelines Removing the MemoryInstalling the Coin-Cell Battery Removing the Coin-Cell BatteryRemoving the Hard Drive Removing the Optical Drive Installing the Hard DrivePage Removing the Speakers Installing the Optical DriveRemoving the Power Supply Installing the SpeakersPage Page Removing the Heat Sink Installing the Power SupplyInstalling the Heat Sink Removing the Processor Installing the ProcessorRemoving the System Fan Removing the Thermal Sensor Installing the System FanPage Removing the Power Switch Installing the Front Thermal SensorRelease the power-switch cable from the chassis clips Page Removing the Input/Output I/O Panel Installing the Power SwitchPage Removing the System Board Installing the Input/Output I/O PanelPage Installing the System Board System Board Components PCI Card connectorBoot Sequence System SetupFollowing table displays the system setup navigation keys Navigation KeysOption Description System Setup OptionsOptionDescription Default Setting All drives are enabledSecurity features Admin PasswordDrive does not have a password set by default Enter the old passwordComputrace Service from Absolute Software AC Recovery Disabled by defaultLoss. You can set the AC Recovery to Power Off defaultKeyboard Errors Is enabled by defaultSequence required to enter the Bios Boot Option Menu By defaultJumper Settings Updating the BiosJumper Setting Description DefaultPassword Type Description System and Setup PasswordPassword that you must enter to log on to your system Setup passwordDisabling a System Password Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Power LED Diagnostics Troubleshooting Your ComputerBeep Code Error MessagesPlease run Setup program Configuration Take the appropriate action to resolve the problemPopulate DIMM1 Seated or installed Keyboard failure Controller may be faultyPlug and play configuration error Error Message Description Not a boot disketteRead fault Reset failed Disk re-set operation failed Sector not foundFeature Technical SpecificationsSpecification Feature SpecificationIntegrated Integrated Two channel high definition audioCommunication System Chipset Intel C216 chipset DMA ChannelsOne 36-pin connector PCI 2.3 data width maximum 32 bits One 120-pin connectorOne 164-pin connector FourDrive Front of the computer Power button lightBack of the computer Network and the computerSupply may be defective. AC power must be Lights up. If the LED does not light up, the powerElectrical outlet Connected during this testFeature Specification Contacting Dell