Figure 23.
Installing the Input/Output (I/O) Panel
1.Insert the I/O panel into the slot on the chassis front.
2.Slide the I/O panel towards the right of the computer to secure to the chassis.
3.Tighten the screw to secure the I/O panel to the chassis.
4.Thread the I/O panel/FlyWire cable into the chassis clip.
5.Connect the I/O panel/FlyWire cable to the system board.
6.Install the:
a)front panel
b)cover
7.Follow the procedures in After Working Inside Your Computer.
Removing the System Board
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove the:
a)cover
b)front panel
c)expansion card(s)
d)heat sink
e)processor
3.Disconnect all the cables connected to the system board.
29