Dell T1650 owner manual Removing the Processor, Installing the Processor, Removing the System Fan

Page 21

Removing the Processor

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the:

a)cover

b)heat sink

3.Press the release lever down and then move it outward to release it from the retention hook. Lift the processor cover and remove the processor from the socket, and place it in an antistatic bag.

Installing the Processor

1.Insert the processor into the processor socket. Ensure that the processor is properly seated.

2.Lower the processor cover.

3.Press the release lever down and then move it inward to secure it with the retention hook.

4.Install the:

a)heat sink

b)cover

5.Follow the procedures in After Working Inside Your Computer.

Removing the System Fan

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the cover.

3.Press the clip to release and disconnect the system fan cable from the system board.

Image 21

Contents Regulatory Model D09M Regulatory Type D09M004 Dell Inc Contents Diagnostics System SetupTroubleshooting Your Computer Technical Specifications Contacting DellBefore Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerInstalling the Cover Removing and Installing ComponentsRecommended Tools Removing the CoverInstalling the Intrusion Switch Removing the Intrusion SwitchRemoving the Front Panel Install the coverRemoving the Expansion Card Installing the Front PanelInstalling the Memory Installing the Expansion CardMemory Module Guidelines Removing the MemoryRemoving the Coin-Cell Battery Installing the Coin-Cell BatteryRemoving the Hard Drive Removing the Optical Drive Installing the Hard DrivePage Removing the Speakers Installing the Optical DriveRemoving the Power Supply Installing the SpeakersPage Page Removing the Heat Sink Installing the Power SupplyInstalling the Heat Sink Installing the Processor Removing the ProcessorRemoving the System Fan Removing the Thermal Sensor Installing the System FanPage Removing the Power Switch Installing the Front Thermal SensorRelease the power-switch cable from the chassis clips Page Removing the Input/Output I/O Panel Installing the Power SwitchPage Removing the System Board Installing the Input/Output I/O PanelPage Installing the System Board System Board Components PCI Card connectorBoot Sequence System SetupFollowing table displays the system setup navigation keys Navigation KeysOption Description System Setup OptionsOptionDescription Default Setting All drives are enabledSecurity features Admin PasswordDrive does not have a password set by default Enter the old passwordComputrace Service from Absolute Software AC Recovery Disabled by defaultLoss. You can set the AC Recovery to Power Off defaultKeyboard Errors Is enabled by defaultSequence required to enter the Bios Boot Option Menu By defaultJumper Settings Updating the BiosJumper Setting Description DefaultPassword Type Description System and Setup PasswordPassword that you must enter to log on to your system Setup passwordDisabling a System Password Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Power LED Diagnostics Troubleshooting Your ComputerBeep Code Error MessagesPlease run Setup program Configuration Take the appropriate action to resolve the problemPopulate DIMM1 Seated or installed Keyboard failure Controller may be faultyPlug and play configuration error Error Message Description Not a boot disketteRead fault Reset failed Disk re-set operation failed Sector not foundFeature Technical SpecificationsSpecification Feature SpecificationIntegrated Integrated Two channel high definition audioCommunication System Chipset Intel C216 chipset DMA ChannelsOne 36-pin connector PCI 2.3 data width maximum 32 bits One 120-pin connectorOne 164-pin connector FourDrive Front of the computer Power button lightBack of the computer Network and the computerSupply may be defective. AC power must be Lights up. If the LED does not light up, the powerElectrical outlet Connected during this testFeature Specification Contacting Dell