If the computer generates a drive error message the first time you boot your computer after you install an IDE drive, your drive may not work with the automatic
During POST the computer scans the IDE channels for supported devices and generates a summary message. For example, if the computer detects that a hard drive is connected to the Primary channel and a CD drive is connected to the Secondary channel, it generates the following message:
Performing automatic IDE configuration...
Primary Master: IDE Disk Drive
Secondary Master:
If the computer detects a device during the scan, it sets the device to Auto in system setup. If no device is listed, it sets the device setting to Off in system setup.
If your computer does not reset after you perform these steps, enter system setup and reset the computer to its original settings:
1.Restart your computer.
2.As the system restarts, press <F2> to enter system setup.
3.When the system setup screen appears, press <Alt><F> to load the default settings.
The computer beeps when the settings are restored.
4.Verify that the time, date, and year are correct and the Secondary Drive 0 option is set to Auto.
5.Press <Esc> and then press <Enter> to save your changes and exit.
The computer restarts.
Jumper Settings
NOTICE: Ensure that your computer is turned off and unplugged before you change the jumper settings. Otherwise, damage to your computer or unpredictable results can occur.
CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated.
Jumper Setting | Description |
PSWD | Password features are enabled. |
| (default) |
| Password features are disabled. |
RTCRST