Dell T5600 owner manual Installing the Front Input/Output I/O Panel, Removing the Speaker

Page 30

Figure 16.

6.Remove the screws which secure the front I/O panel to the chassis.

7.Remove the front I/O panel from the chassis.

Installing the Front Input/Output (I/O) Panel

1.Replace the front I/O panel in its slot.

2.Tighten the screws securing the front I/O panel to the chassis

3.Attach the cables to the I/O panel.

4.Slide the USB 3.0 module in its slot.

5.Tighten the screws securing the USB 3.0 module to the front I/O panel.

6.Install:

a)front bezel

b)cover

7.Follow the procedures in After Working Inside Your Computer.

Removing the Speaker

1.Follow the procedures in Before Working On Your Computer.

2.Remove the cover.

3.Disconnect the speaker cable from the system board.

30

Image 30
Contents Regulatory Model D01T Regulatory Type D01T001 Dell Inc Contents Troubleshooting Your Computer System SetupDiagnostics Technical Specifications Contacting DellWorking on Your Computer Before Working Inside Your ComputerTurning Off Your Computer After Working Inside Your ComputerRemoving and Installing Components Removing the Power Supply Unit PSURecommended Tools Installing the Power Supply Unit PSU Removing the CoverInstalling the Cover Removing the Optical DrivePage Page Installing the Optical Drive Removing the Thermal SensorInstalling the Thermal Sensor Removing the Hard DrivePage Removing the Air Tunnel Installing the Hard DriveInstalling the Air Tunnel Removing the MemoryInstalling the Coin-Cell Battery Installing the MemoryRemoving the Coin-Cell Battery Removing the Heat SinkInstalling the Heat Sink Installing the Heat-Sink Fan Removing Heat Sink FanInstalling the Processor Removing the ProcessorRemoving the System Fan Page Page Page Page Installing the System Fan Removing the PSU CardPage Installing the PSU Card Removing the Front BezelInstalling the Front Bezel Removing the Front Input/Output I/O PanelPage Installing the Front Input/Output I/O Panel Removing the SpeakerInstalling the Speaker Removing the System BoardPage Page Installing the System Board System Board ComponentsPage Page Power Supply Unit PSU Lock Additional InformationMemory Module Guidelines Page Navigation Keys System SetupBoot Sequence Keys NavigationBoot List Option System Setup OptionsBoot Sequence Option Description System BoardEnable Smart Reporting This option is disabled by default Enable USB Controller DefaultUSB Configuration Option Description Integrated NICDefault Setting Enable Intel TurboBoost Option Description PCI Bus ConfigurationDefault Setting Enable Intel SpeedStep Non-Uniform Memory AccessSystem Password Enable Intel Virtualization Technology Default SettingAdmin Password Strong PasswordChassis Intrusion Admin Setup LockoutOption Description AC Recovery Auto On TimeUpdating the Bios Password that you must enter to log on to your system System and Setup PasswordPassword Type Description Setup passwordDisabling a System Password Page Diagnostics Enhanced Pre-Boot System Assessment ePSA DiagnosticsPage Troubleshooting Your Computer Diagnostic LEDsPage Page Error Messages Error MessageError Message Page Technical Specifications Feature SpecificationSAS USB Video Video card dependent DVI connector DisplayPort DMS-59 Sata Temperature Operating To 35 C 50 F to 95 F Cm/sec 20 in/sec Page Contacting Dell Visit support.dell.com
Related manuals
Manual 2 pages 11.7 Kb Manual 8 pages 52.96 Kb