Dell T5600 owner manual Installing the Cover, Removing the Optical Drive

Page 9

4.Lift the cover upward to a 45–degree angle, and remove it from the computer.

Installing the Cover

1.Place the computer cover on the chassis.

2.Press down on the computer cover until it clicks into place.

3.Follow the procedures in After Working Inside Your Computer.

Removing the Optical Drive

1.Follow the procedures in Before Working Inside Your Computer.

2.Remove the cover.

3.Disconnect the data and power cables from the optical drive.

9

Image 9
Contents Regulatory Model D01T Regulatory Type D01T001 Dell Inc Contents Diagnostics System SetupTroubleshooting Your Computer Technical Specifications Contacting DellBefore Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerRemoving and Installing Components Removing the Power Supply Unit PSURecommended Tools Removing the Cover Installing the Power Supply Unit PSURemoving the Optical Drive Installing the CoverPage Page Removing the Thermal Sensor Installing the Optical DriveRemoving the Hard Drive Installing the Thermal SensorPage Installing the Air Tunnel Installing the Hard DriveRemoving the Air Tunnel Removing the MemoryRemoving the Coin-Cell Battery Installing the MemoryInstalling the Coin-Cell Battery Removing the Heat SinkInstalling the Heat Sink Removing Heat Sink Fan Installing the Heat-Sink FanRemoving the Processor Installing the ProcessorRemoving the System Fan Page Page Page Page Removing the PSU Card Installing the System FanPage Removing the Front Bezel Installing the PSU CardRemoving the Front Input/Output I/O Panel Installing the Front BezelPage Removing the Speaker Installing the Front Input/Output I/O PanelRemoving the System Board Installing the SpeakerPage Page System Board Components Installing the System BoardPage Page Power Supply Unit PSU Lock Additional InformationMemory Module Guidelines Page Boot Sequence System SetupNavigation Keys Keys NavigationBoot Sequence System Setup OptionsBoot List Option Option Description System BoardUSB Configuration Enable USB Controller DefaultEnable Smart Reporting This option is disabled by default Option Description Integrated NICDefault Setting Enable Intel SpeedStep Option Description PCI Bus ConfigurationDefault Setting Enable Intel TurboBoost Non-Uniform Memory AccessAdmin Password Enable Intel Virtualization Technology Default SettingSystem Password Strong PasswordOption Description AC Recovery Admin Setup LockoutChassis Intrusion Auto On TimeUpdating the Bios Password Type Description System and Setup PasswordPassword that you must enter to log on to your system Setup passwordDisabling a System Password Page Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Diagnostic LEDs Troubleshooting Your ComputerPage Page Error Message Error MessagesError Message Page Feature Specification Technical SpecificationsSAS USB Video Video card dependent DVI connector DisplayPort DMS-59 Sata Temperature Operating To 35 C 50 F to 95 F Cm/sec 20 in/sec Page Visit support.dell.com Contacting Dell
Related manuals
Manual 2 pages 11.7 Kb Manual 8 pages 52.96 Kb