Dell T5600 owner manual Installing the Heat Sink

Page 17

4.Loosen the captive screws that secure the heat sink to the system board.

5.Grip the heat sink and lift it away from the computer.

Installing the Heat Sink

1.Place the heat sink inside the computer.

2.Tighten the captive screws to secure the heat sink to the system board.

3.Connect the heat-sink cable to the system board.

4.Install the cover.

5.Follow the procedures in After Working Inside Your Computer.

17

Image 17

Contents Regulatory Model D01T Regulatory Type D01T001 Dell Inc Contents Diagnostics System SetupTroubleshooting Your Computer Technical Specifications Contacting DellBefore Working Inside Your Computer Working on Your ComputerAfter Working Inside Your Computer Turning Off Your ComputerRecommended Tools Removing and Installing ComponentsRemoving the Power Supply Unit PSU Removing the Cover Installing the Power Supply Unit PSURemoving the Optical Drive Installing the CoverPage Page Removing the Thermal Sensor Installing the Optical DriveRemoving the Hard Drive Installing the Thermal SensorPage Installing the Air Tunnel Installing the Hard DriveRemoving the Air Tunnel Removing the MemoryRemoving the Coin-Cell Battery Installing the MemoryInstalling the Coin-Cell Battery Removing the Heat SinkInstalling the Heat Sink Removing Heat Sink Fan Installing the Heat-Sink FanRemoving the Processor Installing the ProcessorRemoving the System Fan Page Page Page Page Removing the PSU Card Installing the System FanPage Removing the Front Bezel Installing the PSU CardRemoving the Front Input/Output I/O Panel Installing the Front BezelPage Removing the Speaker Installing the Front Input/Output I/O PanelRemoving the System Board Installing the SpeakerPage Page System Board Components Installing the System BoardPage Page Memory Module Guidelines Power Supply Unit PSU LockAdditional Information Page Boot Sequence System SetupNavigation Keys Keys NavigationBoot Sequence System Setup OptionsBoot List Option Option Description System BoardUSB Configuration Enable USB Controller DefaultEnable Smart Reporting This option is disabled by default Option Description Integrated NICDefault Setting Enable Intel SpeedStep Option Description PCI Bus ConfigurationDefault Setting Enable Intel TurboBoost Non-Uniform Memory AccessAdmin Password Enable Intel Virtualization Technology Default SettingSystem Password Strong PasswordOption Description AC Recovery Admin Setup LockoutChassis Intrusion Auto On TimeUpdating the Bios Password Type Description System and Setup PasswordPassword that you must enter to log on to your system Setup passwordDisabling a System Password Page Enhanced Pre-Boot System Assessment ePSA Diagnostics DiagnosticsPage Diagnostic LEDs Troubleshooting Your ComputerPage Page Error Message Error MessagesError Message Page Feature Specification Technical SpecificationsSAS USB Video Video card dependent DVI connector DisplayPort DMS-59 Sata Temperature Operating To 35 C 50 F to 95 F Cm/sec 20 in/sec Page Visit support.dell.com Contacting Dell

Related manuals

Manual 2 pages 11.7 Kb

Manual 8 pages 52.96 Kb