Installing the Display Assembly
1.Align the palmrest assembly on the display assembly.
2.Tighten the screws to secure the display hinges to the palmrest assembly.
3.Route the touch panel, display, and camera cables through the routing tabs.
4.Connect the following cables:
a.touch panel [4], and display cables [3] to the system board
b.camera cable to I/O board [2]
c.antenna cables to the WLAN card [1]
5.Install the:
a.battery
b.base cover
6.Follow the procedures in After Working Inside Your Computer.
Removing the Palmrest Assembly
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove the:
a.base cover
b.battery
c.hard drive
d.speakers
e.WLAN card
f.
g.mSATA card
h.fans
32