Dell 3800 owner manual Installing The Input/Output I/O Panel

Page 19

3.Follow the steps below to disconnect the I/O panel cables:

a.Disconnect the I/O panel and FlyWire cables from the system board.

b.Un-thread the cables from the metal retention clips.

4.Follow the steps below to remove the I/O panel:

a.Remove the screw that secures the I/O panel to the computer.

b.Slide the I/O panel outwards and remove it from the computer.

Installing The Input/Output (I/O) Panel

1.Slide the I/O panel into its slot on the computer.

2.Replace the screw that secures the I/O panel.

3.Route the three cables through the metal clips.

4.Connect the three I/O panel and FlyWire cables to the system board.

19

Image 19

Contents Dell Vostro Page Contents Specifications Contacting Dell Before Working Inside Your Computer Working on Your ComputerTurning Off Your Computer After Working Inside Your Computer Recommended Tools Removing and Installing ComponentsSystem Overview Removing The Cover Installing The CoverRemoving The Bezel Removing The Optical Drive Installing The BezelRemoving The Hard Drive Installing The Optical DriveInstalling The Hard Drive Removing The Power Supply Unit PSU Installing the Expansion CardsRemoving the Expansion Cards Page Removing The Heatsink Installing The Power Supply Unit PSURemoving the Memory Installing The HeatsinkInstalling the Processor Removing the ProcessorRemoving The System Fan Installing the MemoryRemoving The Input/Output I/O Panel Installing The System FanInstalling The Input/Output I/O Panel Removing The System Board System Board Components Installing The System BoardPage Diagnostic Power LED Codes Troubleshooting Your ComputerDiagnostic Error Messages RUN System Setup Program HARD-DISK Drive Configuration ErrorInsert Bootable Media Invalid Configuration INFORMATION-PLEASENo Boot Sector on Hard Drive Licensed Content is not Accessible in MediadirectMemory Allocation Error No Boot Device AvailableNot Enough Memory or RESOURCES. Exit Seek ErrorTIME-OF-DAY Clock Lost Power \ is not ACCESSIBLE. the Device is not ReadySystem Error Messages System Setup Options System SetupSystem Setup Overview Enter System SetupSata AdvancedBoot Wlan PowerSpecifications PCI USBVAC-264 VAC Page Contacting Dell