Dell 410 specifications

Page 43

1 release tab

2 card retention mechanism

3 card retention door

4heat sink captive screws (2)

5.Use a long Phillips screwdriver to loosen the two captive screws, one on each side of the heat-sink assembly.

CAUTION: The heat-sink assembly may be very hot during normal operation. Be sure that it has had sufficient time to cool before you touch it.

6. Rotate the heat-sink assembly towards the rear of the computer, and remove it from the computer.

1

heat sink and fan shroud assembly

2

captive screw housing (2)

 

 

 

 

7.Place the heat-sink assembly on its side in a safe place.

8.Disconnect the system fan cable from the system board.

9.Ensure that all cables have been removed from the routing clips on the top of the system fan assembly.

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Model Dcta August 2006 Rev. A00 Front View of the Computer About Your ComputerBack View of the Computer Back Panel ConnectorsBack to Contents Problem Description Suggested Resolution Advanced TroubleshootingPower Lights Diagnostic LightsCode Cause Beep CodesMessage Possible Cause Corrective Action System setup see Entering System SetupTab Function Dell DiagnosticsDell Diagnostics Main Menu Option FunctionDrivers Reinstalling DriversIdentifying Drivers Click Start, then click Help and Support Resolving Software and Hardware IncompatibilitiesTurning Off Your Computer Before You BeginGetting Started Recommended ToolsBack to Contents Removing the Computer Cover Removing and Installing PartsSystem Board Components Inside View of Your ComputerMemory Overview MemoryAddressing Memory With 4-GB Configurations Installing MemoryPage Removing Memory CardsPCI Cards Page Page Removing a PCI Card PCI Express CardsPage Page Removing a PCI Express Card Removing the Drive Panel Drive PanelsRemoving the Drive-Panel Insert Installing the Drive-Panel InsertDrives Installing the Drive PanelHard Drive General Installation GuidelinesRemoving a Hard Drive Installing a Hard Drive Adding a Second Hard Drive Removing a Floppy Drive Floppy DriveMedia Card Reader Installing a Floppy DriveRemoving a Media Card Reader Installing a Media Card Reader CD/DVD Drive Installing a CD/DVD DriveRemoving a CD/DVD Drive Battery Replacing the Battery Power SupplyInstalling the Power Supply Removing the Power SupplyRemoving the Processor Processor Installing the Processor Page Panel Components PanelRemoving the I/O Panel Page Installing the I/O Panel Removing the Processor Fan Processor FanCard Fan Installing the Processor FanRemoving the System Board Installing the Card FanSystem Board Removing the Card FanReplacing the Computer Cover Installing the System BoardBack to Contents Specifications Drives ConnectorsControls and Lights Physical PowerEnvironmental System Setup Options System Setup ProgramEntering System Setup System Setup ScreensDrives Option Settings Boot SequenceChanging Boot Sequence for the Current Boot Clearing Forgotten PasswordsChanging Boot Sequence for Future Boots Clearing Cmos Settings Flashing the Bios Technical Overview Power Supply DC Connector Pin Assignments Signal Name Color Wire Gauge DC Power Connector P1DC Power Connector P7 DC Power Connector P2DC Power Connect P4 DC Power Connect P3, P5, P8, P9, P13, and P14DC Power Connector P12 DC Power Connectors P10
Related manuals
Manual 63 pages 47.98 Kb Manual 63 pages 47.93 Kb
Top Page Image Contents