Removing and Installing Parts: Dell Dimension E520 Service Manual
1 | serial ATA data cable | 2 | power cable |
4. Press in on the blue tabs on each side of the drive and slide the drive up and out of the computer.
1 | tabs (2) | 2 | hard drive |
5.If removing this drive changes the drive configuration, then be sure to reflect these changes in system setup. When you restart your computer, enter system setup (see System Setup), then go to the "Drives" section of the BIOS and under SATA 0 through 5, set the SATA ports to the correct configuration.
Installing a Hard Drive
1.Follow the procedures in Before You Begin.
2.Remove the computer cover (see Removing the Computer Cover).
3.Check the documentation for the drive to verify that it is configured for your computer.
file:///T/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]