Removing and Installing Parts: Dell Dimension E520 Service Manual
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer.
Removing the Processor
1.Follow the procedures in Before You Begin.
2.Remove the computer cover (see Front View of the Computer).
3.If your computer includes a card retention mechanism, to secure the x16 card in place from the top:
a.Pivot the mechanism upward and gently squeeze in on the sides to release the mechanism from the two tab slots holding it in place.
b.Set the retention mechanism aside.
4.Unhook the floppy drive cable from the clip on the processor shroud and move it out of the way.
1 | floppy cable clip | 2 processor shroud | 3 card retention mechanism |
4 | release tabs (2) |
|
|
5.Using a long Phillips screwdriver, loosen the two captive screws, one on each side of the plastic heat sink assembly shield.
6.Rotate the heat sink assembly toward the rear of the computer, and then lift it from the computer.
file:///T/htdocs/systems/dimE520/en/SM_EN/parts.htm[10/16/2012 1:05:24 PM]