Dell CDPR3 manual Installation

9.If the printer needs to move left or right, loosen the side-to-side screws (T10) and move the printer until the picker fingers are centered over the hole.

10.If the printer needs to move forward or backwards, turn the front-to-back screw (5/32” Allen screw) counterclockwise to move the printer back, or clockwise to move it forward so the picker fingers are aligned over the hole.

1 – Side-to-Side Screws

2 – Front-to-Back Screw

11.With the picker fingers centered over the hole, rotate the leadscrew counterclockwise to move the picker into the hole. The disc should snap into the picker fingers. With the disc held by the picker, finer adjustments can now be made.

12.Move the printer so the right edge of the disc matches the right edge of the print pad. After the side-to-side adjustment is complete, tighten the side-to-side screws.

13.Move the printer with the front-to-back screw so the front edge of the disc is about 0.040”/1mm from the front edge of the print pad. Make sure you are aligning to the front edge of the disc, not the coating on the disc. If necessary, make final adjustments.

1 – Front Edge of Disc

2 – Print Pad

29 Installation