Dell B110 service manual PCI Cards

Page 29

15. To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Cards

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

Your computer provides three slots for PCI cards.

PCI Cards

If you are installing or replacing a card, follow the procedures in the next section. If you are removing, but not replacing a card, see Removing a PCI Card.

If you are replacing a card, remove the current driver for the card from the operating system.

Installing a PCI Card

1.Follow the procedures in Before Your Begin.

2.Unscrew and remove the filler bracket for the card slot you want to use.

CAUTION: Some network adapters automatically start the computer when they are connected to a network. To guard against electrical shock, be sure to unplug your computer from its electrical outlet

Image 29
Contents Abbreviations and Acronyms Getting Started Before You BeginRecommended Tools Turning Off Your ComputerTurn off your computer Open the computer cover Back to ContentsRemoving the Computer Cover Inside View of Your Computer System Board Components Technical OverviewPower Supply DC Connector Pin Assignments Minimum Current a Maximum Current a Pin Number Signal name Wire Color DC Power Connector P1DC Power Connector P2 DC Power Connector P4 DC Power Connectors P8 and P9DC Power Connector P6 Pin Number Signal Name 18-AWG Wire ColorPin Number Signal Name 22-AWG Wire Color DC Power Connector P7Computer Information Technical SpecificationsMemory Video ConnectorsAudio Expansion BusControls and Lights PowerPhysical EnvironmentalBack to Contents Power Lights Advanced TroubleshootingRemove and then reinstall the memory modules Network LightsLight Pattern Problem Description Diagnostic LightsSuggested Resolution Yellow LEDCode Cause Beep CodesEnter the system setup program, verify System setup programSystem Messages Message Possible Cause Corrective ActionFDD Entering System Setup System SetupSystem Setup Screens OverviewDrive Configuration System Setup OptionsSystem Hard-Disk Drive SequenceMemory Information Boot SequenceCPU Information Integrated DevicesOption Settings Boot SequenceChanging Boot Sequence for the Current Boot Power ManagementEnter system setup Clearing Forgotten PasswordsChanging Boot Sequence for Future Boots Replace the computer cover Memory Installation Guidelines Removing and Installing PartsHard Drive Power Supply Floppy Drive Battery MemoryShut down the computer through the Start menu Installing MemoryReplace the computer cover PCI Cards CardsBefore installing any cards Removing the Front Panel Front PanelRemove the computer cover Removing the Front-Panel InsertReattaching the Front Panel Connecting Drive Cables General Installation GuidelinesDrives Hard DriveRemoving a Hard Drive Installing a Hard Drive Page Removing a Floppy Drive Floppy DriveInstalling a Floppy Drive Removing a CD/DVD Drive CD/DVD DriveInstalling a CD/DVD Drive Adding a Second CD or DVD Drive Page Removing the Processor ProcessorInstalling the Processor Page Removing the Fan Assembly Fan AssemblyReplacing the Fan Assembly Removing the System Board Remove the microprocessor heat sink Remove the fan assemblySystem Board Reinstall the fan assembly Installing the System BoardReplacing the Power Supply Power SupplyRemoving the Power Supply Battery Replace the computer cover Replacing the Computer Cover
Related manuals
Manual 116 pages 9.03 Kb Manual 116 pages 3.25 Kb Manual 54 pages 62.66 Kb