Dell B110 Drives, Hard Drive, General Installation Guidelines, Connecting Drive Cables

Page 34

Drives

Your computer supports a combination of these devices:

One hard drive

One optional floppy

Up to two CD or DVD drives

General Installation Guidelines

Connect the IDE hard drive to the system board connector labeled PRI IDE. Connect CD/DVD drives to the connector labeled J6J1.

When you connect two IDE devices to a single IDE interface cable and configure them for the cable select setting, the device attached to the last connector on the interface cable is primary or the boot device (drive 0), and the device attached to the middle connector on the interface cable is the secondary device (drive 1). See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting.

Connecting Drive Cables

When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive and to the system board. Some drives may also have an audio connector; one end of the audio cable will attach to the drive connector and the other will attach to the system board.

Drive Interface Connectors

Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a filled-in hole on the other connector.

When connecting an IDE cable, ensure you align the colored stripe with the pin 1 connector. When disconnecting an IDE cable, grasp the colored pull tab and pull until the connector detaches.

Power Cable Connector

Hard Drive

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

Image 34
Contents Abbreviations and Acronyms Recommended Tools Before You BeginGetting Started Turning Off Your ComputerOpen the computer cover Back to Contents Turn off your computerRemoving the Computer Cover Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments Minimum Current a Maximum Current a DC Power Connector P2 DC Power Connector P1Pin Number Signal name Wire Color DC Power Connector P6 DC Power Connectors P8 and P9DC Power Connector P4 Pin Number Signal Name 18-AWG Wire ColorDC Power Connector P7 Pin Number Signal Name 22-AWG Wire ColorMemory Technical SpecificationsComputer Information Audio ConnectorsVideo Expansion BusPhysical PowerControls and Lights EnvironmentalBack to Contents Remove and then reinstall the memory modules Advanced TroubleshootingPower Lights Network LightsSuggested Resolution Diagnostic LightsLight Pattern Problem Description Yellow LEDBeep Codes Code CauseSystem Messages System setup programEnter the system setup program, verify Message Possible Cause Corrective ActionFDD System Setup Screens System SetupEntering System Setup OverviewSystem System Setup OptionsDrive Configuration Hard-Disk Drive SequenceCPU Information Boot SequenceMemory Information Integrated DevicesChanging Boot Sequence for the Current Boot Boot SequenceOption Settings Power ManagementChanging Boot Sequence for Future Boots Clearing Forgotten PasswordsEnter system setup Replace the computer cover Hard Drive Power Supply Floppy Drive Battery Removing and Installing PartsMemory Installation Guidelines MemoryInstalling Memory Shut down the computer through the Start menuReplace the computer cover Cards PCI CardsBefore installing any cards Front Panel Removing the Front PanelRemoving the Front-Panel Insert Remove the computer coverReattaching the Front Panel Drives General Installation GuidelinesConnecting Drive Cables Hard DriveRemoving a Hard Drive Installing a Hard Drive Page Floppy Drive Removing a Floppy DriveInstalling a Floppy Drive CD/DVD Drive Removing a CD/DVD DriveInstalling a CD/DVD Drive Adding a Second CD or DVD Drive Page Processor Removing the ProcessorInstalling the Processor Page Fan Assembly Removing the Fan AssemblyReplacing the Fan Assembly System Board Remove the microprocessor heat sink Remove the fan assemblyRemoving the System Board Installing the System Board Reinstall the fan assemblyRemoving the Power Supply Power SupplyReplacing the Power Supply Battery Replace the computer cover Replacing the Computer Cover
Related manuals
Manual 116 pages 9.03 Kb Manual 116 pages 3.25 Kb Manual 54 pages 62.66 Kb