Dell B110 service manual Before installing any cards

Page 30

before installing any cards.

3.Align the cutout on the bottom of the card with the crossbar in the system board connector. Gently rock the card into the connector until it is fully seated.

Ensure that the card is fully seated and that its bracket is within the card slot.

4.Secure the card bracket with the screw you removed in step 2.

5.Connect any cables that should be attached to the card.

For information about the card's cable connections, see the documentation for the card.

NOTICE: Do not route card cables over or behind the cards. Cables routed over the cards can cause damage to the equipment.

6.If you installed a sound card:

a.Enter system setup, select Audio Controller, and then change the setting to Off.

b.Connect external audio devices to the sound card's connectors. Do not connect external audio devices to the

Image 30

Contents Abbreviations and Acronyms Recommended Tools Before You BeginGetting Started Turning Off Your ComputerOpen the computer cover Back to Contents Turn off your computerRemoving the Computer Cover Technical Overview Inside View of Your Computer System Board ComponentsPower Supply DC Connector Pin Assignments Minimum Current a Maximum Current a DC Power Connector P1 DC Power Connector P2Pin Number Signal name Wire Color DC Power Connector P6 DC Power Connectors P8 and P9DC Power Connector P4 Pin Number Signal Name 18-AWG Wire ColorDC Power Connector P7 Pin Number Signal Name 22-AWG Wire ColorTechnical Specifications MemoryComputer Information Audio ConnectorsVideo Expansion BusPhysical PowerControls and Lights EnvironmentalBack to Contents Remove and then reinstall the memory modules Advanced TroubleshootingPower Lights Network LightsSuggested Resolution Diagnostic LightsLight Pattern Problem Description Yellow LEDBeep Codes Code CauseSystem Messages System setup programEnter the system setup program, verify Message Possible Cause Corrective ActionFDD System Setup Screens System SetupEntering System Setup OverviewSystem System Setup OptionsDrive Configuration Hard-Disk Drive SequenceCPU Information Boot SequenceMemory Information Integrated DevicesChanging Boot Sequence for the Current Boot Boot SequenceOption Settings Power ManagementClearing Forgotten Passwords Changing Boot Sequence for Future BootsEnter system setup Replace the computer cover Hard Drive Power Supply Floppy Drive Battery Removing and Installing PartsMemory Installation Guidelines MemoryInstalling Memory Shut down the computer through the Start menuReplace the computer cover Cards PCI CardsBefore installing any cards Front Panel Removing the Front PanelRemoving the Front-Panel Insert Remove the computer coverReattaching the Front Panel Drives General Installation GuidelinesConnecting Drive Cables Hard DriveRemoving a Hard Drive Installing a Hard Drive Page Floppy Drive Removing a Floppy DriveInstalling a Floppy Drive CD/DVD Drive Removing a CD/DVD DriveInstalling a CD/DVD Drive Adding a Second CD or DVD Drive Page Processor Removing the ProcessorInstalling the Processor Page Fan Assembly Removing the Fan AssemblyReplacing the Fan Assembly Remove the microprocessor heat sink Remove the fan assembly System BoardRemoving the System Board Installing the System Board Reinstall the fan assemblyPower Supply Removing the Power SupplyReplacing the Power Supply Battery Replace the computer cover Replacing the Computer Cover

Related manuals

Manual 116 pages 9.03 Kb

Manual 116 pages 3.25 Kb

Manual 54 pages 62.66 Kb