20. 8–pin power connector
Installing the System Board
1.Place the system board on the computer.
2.Connect all the cables to the system board.
3.Tighten the screws to secure the system board to the base panel.
4.Install:
a)
b)converter board
c)input/output (I/O) board shield
d)power supply unit
e)
f)hard drive
g)optical drive
h)memory
i)
j)VESA mount bracket
k)back cover
l)VESA stand
5.Follow the procedures in After Working Inside Your Computer.
Removing the Heat Sink (Graphics Card)
1.Follow the procedures in Before Working Inside Your Computer.
2.Remove the:
a)VESA stand
b)back cover
c)VESA mount bracket
d)
e)memory
f)optical drive
g)hard drive
h)
i)power supply unit
j)input/output (I/O) board shield
k)converter board
l)
m)system board
3.Disconnect the fan cable connected to the system board and lift the system board to its back.
34