Graco Inc 224893, 224895, 224894, 224892, 308178 important safety instructions Toxic Fluid Hazard

Page 3

WARNING

TOXIC FLUID HAZARD

Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin, inhaled, or swallowed.

DKnow the specific hazards of the fluid you are using.

DStore hazardous fluid in an approved container. Dispose of hazardous fluid according to all local, state and national guidelines.

DAlways wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and solvent manufacturer.

DGraco does not manufacture or supply the reactive chemical components that may be used in this equipment and is not responsible for injury or property loss, damage, expense or claims (direct or consequential) that arise from the use of such chemical components.

FIRE AND EXPLOSION HAZARD

Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result in a fire or explosion and serious injury.

DGround the equipment. See Grounding on page 4.

DIf there is any static sparking or you feel an electric shock while using this equipment, stop pumping immediately. Do not use the equipment until you identify and correct the problem.

DProvide fresh air ventilation to avoid the buildup of flammable fumes from solvents or the fluid being pumped.

DKeep the work area free of debris, including solvent, rags, and gasoline.

DElectrically disconnect all equipment in the work area.

DExtinguish all open flames or pilot lights in the work area.

DDo not smoke in the work area.

DDo not turn on or off any light switch in the work area while operating or if fumes are present.

DDo not operate a gasoline engine in the work area.

DNever use 1.1.1–trichloroethane, methylene chloride, other halogenated hydrocarbon solvents or fluids containing such solvents in pressurized aluminum equipment. Such use could result in a chemical reaction, with the possibility of explosion.

MOVING PARTS HAZARD

Moving parts, such as the air motor piston in the pump, can pinch or amputate your fingers.

DKeep clear of all moving parts when starting or operating the pump.

DBefore servicing this surge tank, follow the Pressure Relief Procedure on page 4 to prevent the equipment from starting accidentally.

United States Government safety standards have been adopted under the Occupational Safety and Health Act. You should consult these standards––particularly the General Standards, Part 1910.

308178 3

Image 3
Contents Table of Contents Instructions-Parts ListEquipment Misuse Hazard SymbolsToxic Fluid Hazard Fluid Compatibility InstallationPressure Relief Procedure System PressureKEY Installation General InformationAir Exhaust Ventilation Shutdown Operation and MaintenanceOperating the Surge Suppressor Flushing the SystemProblem Cause Solution TroubleshootingService Servicing the Shaft O-RingsServicing the Diaphragm and Shaft Servicing the Fluid Inlet and Outlet Air inlet 1/4 nptf Chamfer faces out 110004 *15 Parts DrawingPart Description Qty Parts ListsRepair Kits Dimensional Drawing Manual Change Summary Technical Data308178 Page 308178 Graco Information Graco Standard Warranty