Information you will need about your
| This is the Username needed access | the | Router’s | Record info here |
Username | management interface. When you attempt to connect to the |
| ||
device through a web browser you will be prompted to enter |
| |||
| this Username. The default Username for the Router is |
| ||
| admin. This may be changed by the user. |
|
|
|
|
|
| ||
Password | This is the Password you will be prompted to enter when you |
| ||
access the Router’s management interface. The default |
| |||
| Password is admin. This may be changed by the user. |
| ||
|
|
| ||
| This is the IP address you will enter into the Address field of |
| ||
| your web browser to access the Router’s configuration |
| ||
LAN IP addresses for the | graphical user interface (GUI) using a web | browser. The |
| |
default IP address is 10.1.1.1. This may be changed to suit |
| |||
|
| |||
any IP address scheme the user desires. This address will be |
| |||
|
| |||
| the base IP address used for DHCP service on the LAN when |
| ||
| DHCP is enabled. |
|
|
|
|
|
| ||
LAN Subnet Mask for the | This is the subnet mask used by the |
| ||
used throughout your LAN. The default subnet | mask is |
| ||
| ||||
255.0.0.0. This can be changed later. |
|
|
| |
|
|
|
| |
|
|
|
|
|
Information you will need about your LAN or computer:
| If your computer has an Ethernet NIC, you can connect the | Record info here |
Ethernet NIC |
| |
You can also use the Ethernet port on the |
| |
| connect to other Ethernet devices, such as a Wireless |
|
| Access Point. |
|
|
|
|
| Your |
|
| be a DHCP server. This means that it can assign an IP |
|
| address, subnet mask, and a default gateway address to |
|
DHCP Client status | computers on your LAN. The default range of IP addresses |
|
the |
| |
|
| |
| Your computer (or computers) needs to be configured to |
|
| Obtain an IP address automatically (that is, they need to |
|
| be configured as DHCP clients.) |
|
|
|
|
Once you have the above information, you are ready to setup and configure your
|
|
|
| The Router may be reset to its factory default settings by performing a Restore |
|
|
|
|
| settings operation within the management interface. If you cannot gain access to |
|
|
|
|
| the management interface, you may opt to use the Reset button on the rear panel of |
|
Note |
| ||||
| the device. |
| |||
|
|
|
|
| |
|
|
|
|
|
|
3