D-Link DSL-500T manual Hardware, Software

Page 4

DSL-500T DSL Router User’s Guide

LIMITATION OF LIABILITY

IN NO EVENT WILL D-LINK BE LIABLE FOR ANY DAMAGES, INCLUDING LOSS OF DATA, LOSS OF PROFITS, COST OF COVER OR OTHER INCIDENTAL, CONSEQUENTIAL OR INDIRECT DAMAGES ARISING OUT THE INSTALLATION, MAINTENANCE, USE, PERFORMANCE, FAILURE OR INTERRUPTION OF A D- LINK PRODUCT, HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY. THIS LIMITATION WILL APPLY EVEN IF D-LINK HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.

IF YOU PURCHASED A D-LINK PRODUCT IN THE UNITED STATES, SOME STATES DO NOT ALLOW THE LIMITATION OR EXCLUSION OF LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.

Limited Warranty

Hardware:

D-Link warrants each of its hardware products to be free from defects in workmanship and materials under normal use and service for a period commencing on the date of purchase from D-Link or its Authorized Reseller and extending for the length of time stipulated by the Authorized Reseller or D-Link Branch Office nearest to the place of purchase.

This Warranty applies on the condition that the product Registration Card is filled out and returned to a D-Link office within ninety (90) days of purchase. A list of D-Link offices is provided at the back of this manual, together with a copy of the Registration Card.

If the product proves defective within the applicable warranty period, D-Link will provide repair or replacement of the product. D-Link shall have the sole discretion whether to repair or replace, and replacement product may be new or reconditioned. Replacement product shall be of equivalent or better specifications, relative to the defective product, but need not be identical. Any product or part repaired by D-Link pursuant to this warranty shall have a warranty period of not less than 90 days, from date of such repair, irrespective of any earlier expiration of original warranty period. When D-Link provides replacement, then the defective product becomes the property of D-Link.

Warranty service may be obtained by contacting a D-Link office within the applicable warranty period, and requesting a Return Material Authorization (RMA) number. If a Registration Card for the product in question has not been returned to D-Link, then a proof of purchase (such as a copy of the dated purchase invoice) must be provided. If Purchaser's circumstances require special handling of warranty correction, then at the time of requesting RMA number, Purchaser may also propose special procedure as may be suitable to the case.

After an RMA number is issued, the defective product must be packaged securely in the original or other suitable shipping package to ensure that it will not be damaged in transit, and the RMA number must be prominently marked on the outside of the package. The package must be mailed or otherwise shipped to D-Link with all costs of mailing/shipping/insurance prepaid. D-Link shall never be responsible for any software, firmware, information, or memory data of Purchaser contained in, stored on, or integrated with any product returned to D-Link pursuant to this warranty.

Any package returned to D-Link without an RMA number will be rejected and shipped back to Purchaser at Purchaser's expense, and D-Link reserves the right in such a case to levy a reasonable handling charge in addition mailing or shipping costs.

Software:

Warranty service for software products may be obtained by contacting a D-Link office within the applicable warranty period. A list of D-Link offices is provided at the back of this manual, together with a copy of the Registration Card. If a Registration Card for the product in question has not been returned to a D-Link office, then a proof of purchase (such as a copy of the dated purchase invoice) must be provided when requesting warranty service. The term "purchase" in this software warranty refers to the purchase transaction and resulting license to use such software.

D-Link warrants that its software products will perform in substantial conformance with the applicable product documentation provided by D-Link with such software product, for a period of ninety (90) days from the date of purchase from D-Link or its Authorized Reseller. D-Link warrants the magnetic media, on which D-Link provides its software product, against failure during the same warranty period. This warranty applies to purchased software, and to replacement software provided by D-Link pursuant to this warranty, but shall not apply to any update or replacement which may be provided for download via the Internet, or to any update which may otherwise be provided free of charge.

D-Link's sole obligation under this software warranty shall be to replace any defective software product with product which substantially conforms to D-Link's applicable product documentation. Purchaser assumes responsibility for the selection of appropriate application and system/platform software and associated reference materials. D-Link makes no warranty that its software products will work in combination with any hardware, or any application or system/platform software product provided by any third party, excepting only such products as are expressly represented, in D-Link's applicable product documentation as being compatible. D-Link's obligation under this warranty shall be a reasonable effort to provide compatibility, but D-Link shall have no obligation to provide compatibility when there is fault in the third-party hardware or software. D-Link makes no warranty that operation of its software products will be uninterrupted or absolutely error-free, and no warranty that all defects in the software product, within or without the scope of D-Link's applicable product documentation, will be corrected.

iv

Image 4
Contents DSL-500T Adsl Router User’s Guide DSL-500T DSL Router User’s Guide FCC WarningWichtige Sicherheitshinweise Warranties ExclusiveHardware SoftwareWarranty and Registration Information for USA Only DSL-500T DSL Router User’s Guide Table of Contents Update Gateway Ping Test OAM Test About This User’s Guide Installation RequirementsBefore You Start Additional Software Ethernet Port NIC AdapterAbout Clip Connections RFC Information you will need from your Adsl service provider Information you will need about your LAN or computer What is ADSL? Router Description and OperationRouter Features Standards Compatibility and Compliance Front Panel Display Packing ListRear Panel Connections Power on Router Factory Reset ButtonHub or Switch to Router Connection Network ConnectionsConnect Adsl Line Connect Router to EthernetComputer to Router Connection Configuring IP Settings on Your Computer Wan Configuration SummaryConfigure Windows XP for Dhcp DSL-500T Adsl Router User’s Guide Configure Windows 2000 for Dhcp WindowsWindows ME Configure Windows ME for DhcpWindows 95 and Windows Configure Windows NT 4.0 for Dhcp Configure Windows 95 and Windows 98 for DhcpWindows NT 4.0 Workstations Access the Configuration Manager Login to HomeConfigure the Router Home Status Information windowSetup Menu Opening Setup windowDSL Modulation Settings DSL Setup menu change modulation typeConfigure Connection 1 for PPPoA PPPoA Connection 1 Setup menuConfigure Connection 1 for PPPoE Change the Connection TypeConfigure Connection 1 for Bridge Setup Configure Connection 1 for Bridge Configure Connection 1 for Static IP for WAN Setup Configure Connection 1 for Static IP for the WANConfigure Connection 1 for Dhcp for WAN Setup Configure Connection 1 for Dhcp service for the WANConfigure Connection 1 for Clip 10. Setup Configure Connection 1 for Clip IPoACreate a New Connection 11. Setup a New Connection Connection New Connection Example 1 Create a New PPPoE Connection12. Setup a New Connection Connection New Connection Example 2 Create a New Bridge ConnectionDhcp Configuration for LAN Dhcp Parameter Description Start IPEnd IP Lease TimeEnable Dhcp Relay 14. Configure Dhcp Relay Service15. Configure Management IP Management IPSave Configuration Changes 16. Router Tools Menus17. Available System Commands Advanced Router Management UPnP Advanced UPnP windowLAN Clients Setup LAN ClientsPort Forwarding Advanced Port Forwarding windowCategory Available Rules Games Audio/VideoApplications ServersSet up Custom Port Forwarding Rules Port Forwarding User Rules Management Access Control Access Control menuVPN Enable/Disable NAT and Firewall Advanced SecurityBridge Filters Setup Remote ManagementDMZ IP Address Multicast Pass-through 10. Multicast pass-through menuStatic Routing 11. Static Routing menuDynamic Routing 12. Dynamic Routing RIP menuMultiple Virtual Connections Tools and Utility Menus 13. Tools and utility menu linksUser Management 14. User Management menuSystem Commands RestoreSystem Function Description Save All RestartRemote Log 16. Remote Log menuUpdate Gateway 17. Tools Update Gateway windowPing Test 18. Tools Ping Test windowOAM Test 19. Tools OAM Test windowStatus Menus 20. Status display linksNetwork Statistics 21. Network Statistics windowConnection Status Dhcp ClientsModem Status Product InformationSystem Log Help MenuStandards ProtocolsData Transfer RatePhysical and Environmental FCC Class B, CE Class BAssigning Network IP Addresses Using the Default IP AddressManual IP Address Assignment IP Setup Example #2 Using DhcpChanging the IP Address of the Router IP Concepts IP AddressesIP Network Classes Class Beginning Address Ending AddressSubnet Mask IP Class Subnet MaskMicrofilter Installation MicrofiltersLine Splitter Installation Line SplitterPage Offices Japan Link Japan Link U.S.A Registration Card