D-Link manual Web Configuration, Factory Default Settings for the DWL-810+

5.Web Configuration

Before using the Web Configuration for the DWL-810+, please consider the following:

You will need a JavaScript-enabled web-browser such as the Internet Explorer 6.0 or later, or the Netscape Navigator 6.0 or later.

The computer that you are using for initial configuration must have an IP Address within the same range as the IP Address of the DWL- 810+. The DWL-810+ has a default IP Address of 192.168.0.30 with a subnet mask of 255.255.255.0

You will need to assign a Static IP Address to the computer that you are using to configure the DWL-810+, within the IP Address Range of the DWL-810+. For example, you can assign a Static IP address of 192.168.0.2 with a subnet mask of 255.255.255.0 (Please refer to the Appendix section of the Quick Installation Guide.)

Factory Default Settings for the DWL-810+

Operating Mode	Infrastructure
SSID	default
Channel	6
Transmission rates	Auto
Encryption	No
Administrator password	Blank (no password needed)
IP Address mode	Static
IP Address	192.168.0.30
IP Subnet	255.255.255.0
username	admin (all lower case)

12