NETGEAR WNR2000V3 manual Checking Basic Router Functions

Page 31

–Some cable modem services require you to use the MAC address of the computer registered on the account. If so, in the Router MAC Address section of the Basic Settings menu, select “Use this Computer’s MAC Address.” Click Apply to save your settings. Restart the network in the correct sequence.

•Check the router status lights to verify correct router operation. If the Power light does not turn solid green within 2 minutes after turning the router on, reset the router according to the instructions in “Restoring the Default Password and Configuration Settings” on page 36.

Checking Basic Router Functions

After you turn on power to the router, check that the following sequence of events has occurred:

1.When power is first applied, verify that the power light is on (see “Front Panel” on page 3 for an illustration).

2.Verify that the power light turns amber within a few seconds, indicating that the self-test procedure is running.

3.After approximately 20 seconds, verify that:

a.The color of the power light changes to green.

b.The LAN port lights are lit for any local ports that are connected.

If a port’s light is lit, a link has been established to the connected device. If a LAN port is connected to a 100 Mbps device, verify that the port’s light is green. If the port is 10 Mbps, the light will be amber.

c.The Internet port is connected and its light is lit.

4.If you have enabled WPS security, verify that the WPS button light on the front panel turns off. If the correct behavior does not occur, check for a remedy from the following list:

•Power Light Not On. If the Power and other lights are off (see “Connecting Your Wireless Router” on page 13), check the following:

–Make sure that the power cord is properly connected to your router and that the power adapter is properly connected to a functioning power outlet.

–Check that you are using the power adapter supplied by NETGEAR for this product.

If the error persists, you have a hardware problem and should contact technical support.

•Power Light Blinks Green Slowly and Continuously. The router firmware is corrupted. To restore your firmware:

Troubleshooting

27

Page 30 Page 32
Image 31
Page 30 Page 32
Contents N300 Wireless Router WNR2000v3 Setup Manual Trademarks Contents Technical Specifications Unpacking Your New Router Getting to Know Your Wireless RouterTo prepare your router for installation Front Panel Hardware FeaturesLAN Back Panel Router Label Positioning Your Wireless RouterInstalling Your Wireless Router Updating Your Router Firmware Using the Netgear genie Installing Your Router Using the Netgear genieInternet Accessing Your Router After Installation Manually Installing Your Router Connecting Your Wireless Router Internet To start your network Verifying Your Connection Setting Up Your Router for Internet Access Firmware Upgrade Assistant screen will display Wireless Network on Read Troubleshooting on Configuring Your Wireless Network Setting Your Ssid and Wireless Security Using Push N Connect WPS to Configure Your Wireless Network To add a wireless device using WPS Configuring Your Wireless Network Basic Setup Checklist TroubleshootingChecking Basic Router Functions Troubleshooting Troubleshooting Login Problems Obtaining an Internet IP Address Checking the Internet Service ConnectionTroubleshooting PPPoE Troubleshooting Internet Browsing Using the Ping Utility to TroubleshootTesting the Path from Your Computer to Your Router Testing the Path from a Computer to the Internet Default Configuration Settings Technical SpecificationsFeature Default Setting Wireless Restoring the Default Password and Configuration Settings Related Documents Related DocumentsRegistration and Certifications
Top Page Image Contents