NETGEAR XE104 manual Off

Page 17

XE104 User Guide

1.First, connect a XE104 Wall-Plugged Ethernet Switch to a LAN port on the router so that the PowerLine network can gain access to the internet.

OFF

ON

WARNING!

Figure 3-3

Do not connect the XE104 85 Mbps Wall-Plugged Ethernet Switch to a power strip, extension cord, or surge protector as this may prevent them from working properly or degrade the network performance.

a.Plug the blue Ethernet cable that came in the box into a LAN port on your router or switch in your network.

Figure 3-4

b.Plug the XE104 into an electrical outlet near the router.

Installing the XE104 Wall-Plugged Ethernet Switch

3-3

v1.0, September 2005

Image 17
Contents XE104 User Guide Trademarks Product and Publication Details V1.0, September Contents Chapter Troubleshooting Audience, Scope, Conventions, and Formats Chapter About This ManualHow to Print this Manual How to Use This ManualPrinting a Chapter XE104 User Guide Chapter Introduction Key FeaturesConnectors, Ports, and Label Information Package ContentsStatus Light Descriptions XE104 Wall-Plugged Ethernet SwitchLabel on the Rear Panel of the XE104 Ethernet PortsHow the PowerLine Switch Fits in Your Network Installing the XE104 Wall-Plugged Ethernet SwitchConnect an XE104 to the Router Prepare to Install Your PowerLine SwitchOFF Connect other Ethernet PowerLine Switches XE104 User Guide XE104 User Guide XE104 User Guide XE104 User Guide Set Your Network Password XE104 User Guide Add a Device to an Existing PowerLine Network Adding a New Device from a Remotely Connected Computer Adding a New Device from a Locally Connected ComputerBasic Functioning Netgear Product Registration, Support, and DocumentationEthernet Light is Off Power Light Not OnHomePlug Light Not On