NETGEAR manual XE104 User Guide

Page 24

XE104 User Guide

b.Start the PowerLine encryption utility and ensure that the Main tab is selected.

Figure 3-11

c.Check that the utility lists all the remote PowerLine devices

d.Select a PowerLine device and, if more than one remote device is listed, identify it from the MAC address.

e.Click the button labelled Enter Password.

Figure 3-12

f.Enter the password recorded from the label on the back of the selected PowerLine device.

g.Click OK.

3-10

Installing the XE104 Wall-Plugged Ethernet Switch

v1.0, September 2005

Image 24
Contents XE104 User Guide Trademarks Product and Publication Details V1.0, September Contents Chapter Troubleshooting Chapter About This Manual Audience, Scope, Conventions, and FormatsHow to Use This Manual How to Print this ManualPrinting a Chapter XE104 User Guide Key Features Chapter IntroductionPackage Contents Connectors, Ports, and Label InformationXE104 Wall-Plugged Ethernet Switch Status Light DescriptionsEthernet Ports Label on the Rear Panel of the XE104Installing the XE104 Wall-Plugged Ethernet Switch How the PowerLine Switch Fits in Your NetworkPrepare to Install Your PowerLine Switch Connect an XE104 to the RouterOFF Connect other Ethernet PowerLine Switches XE104 User Guide XE104 User Guide XE104 User Guide XE104 User Guide Set Your Network Password XE104 User Guide Add a Device to an Existing PowerLine Network Adding a New Device from a Locally Connected Computer Adding a New Device from a Remotely Connected ComputerNetgear Product Registration, Support, and Documentation Basic FunctioningPower Light Not On HomePlug Light Not OnEthernet Light is Off